Cisco Aironet 1530 Manuel de démarrage - Page 21

Parcourez en ligne ou téléchargez le pdf Manuel de démarrage pour {nom_de_la_catégorie} Cisco Aironet 1530. Cisco Aironet 1530 41 pages. Outdoor access points

Imprimer la page

If you will be using a streetlight power tap adapter, position the access point within

Note

3 ft (1 m) of the outdoor light control. The AC/DC adapter must be used with street

light power tap.

Determine which size of band clamp is needed based on the pole diameter. Slide the two

Step 2

clamps through the top and bottom set of of mounting slots (see

bracket to the pole.

Step 3

Wrap the band clamps around the pole and slide them into the second set of top and bottom

mounting slots on the bracket. Lightly tighten the clamps. Only tighten them enough to keep

the bracket from sliding down the pole.

Screw an M6 bolt into each of the four bolt holes on the back side of the access point. Do not

Step 4

screw the bolt in all the way. Leave a gap of about 0.13" (3.3mm).

Position the four bolts on the access point into the bracket keyhole slots. Check to be sure that

Step 5

the access point is properly seated in the slots.(See

The access point should be positioned with the LEDs on the bottom to allow viewing

Note

from the ground.

Using a 10mm wrench, tighten the four bolts that connect the access point to the bracket to

Step 6

a torque of 40 in-lbf.

Locate the access point to its final position. Tighten the band clamps with the wrench so that

Step 7

the access point does not slide on the pole. Be sure that the clamps are tight enough that the

AP does not move.

Continue with the

Step 8

Grounding the Access Point, page

Figure

23.

9) and mount the