Cisco Aironet 1600 Series Manuel de démarrage - Page 12
Parcourez en ligne ou téléchargez le pdf Manuel de démarrage pour {nom_de_la_catégorie} Cisco Aironet 1600 Series. Cisco Aironet 1600 Series 39 pages. Aironet 1600 series access point
Également pour Cisco Aironet 1600 Series : Fiche technique (16 pages)
Imprimer la page
Pre-Installation Configuration Setup
The pre-installation configuration setup is shown in
Figure 4
Pre-Installation Configuration Setup
To perform pre-installation configuration, perform the following steps:
Step 1
Make sure that the Cisco wireless LAN controller DS port is connected to the network. Use
the CLI, web-browser interface, or Cisco Prime Infrastructure procedures as described in the
appropriate Cisco wireless LAN controller guide.
a. Make sure that access points have Layer 3 connectivity to the Cisco wireless LAN controller
Management Interface.
b. Configure the switch to which your access point is to attach. See the Cisco Wireless LAN
Controller Configuration Guide for additional information.
c. Set the Cisco wireless LAN controller as the master so that new access points always join with
it.
d. Make sure DHCP is enabled on the network. The access point must receive its IP address
through DHCP.
12
Figure
Controller
Layer 3
devices
Cisco Aironet
access points
4.