Epson 1280 - Stylus Photo Color Inkjet Printer Manuel d'instructions d'installation - Page 3

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions d'installation pour {nom_de_la_catégorie} Epson 1280 - Stylus Photo Color Inkjet Printer. Epson 1280 - Stylus Photo Color Inkjet Printer 8 pages. Product support bulletin(s)
Également pour Epson 1280 - Stylus Photo Color Inkjet Printer : Remplacement des cartouches (2 pages), Bulletin d'information sur les produits (6 pages), Bulletin d'information sur les produits (1 pages), Manuel complémentaire (1 pages), Manuel de l'utilisateur (27 pages), Manuel de compatibilité (1 pages), Manuel complémentaire (2 pages), Commencer ici (2 pages), Brochure & Specs (2 pages), Informations sur le produit (13 pages), Commencer ici Manuel (6 pages), Spécifications (2 pages), Manuel de l'utilisateur (12 pages), Bulletin d'information sur les produits (3 pages), Bulletin d'information sur les produits (2 pages), Bulletin d'information sur les produits (4 pages), Bulletin d'information sur les produits (7 pages), Manuel de démarrage (32 pages)

Epson 1280 - Stylus Photo Color Inkjet Printer Manuel d'instructions d'installation
chip. Make sure it is seated at the bottom of the cartridge holder. If it is not
seated all the way down, the chip may make partial contact causing it to become
unusable. Do the same with the black cartridge. Both should now be firmly in place.
You don't want them to be lifted by accident or by the tubes pulling on them.
Next, install the nylon tie wrap and hold down strap as shown below. It is important
to get it in the exact position as shown in the photo, so it will be in the depressed
area of the chassis. See photo. This is your insurance that the cartridges will not
pop up and cause damage to the electronic chips on the front of the cartridges. If
you have "red light" problems after installing your CFS, it is due to the chips on the
carts being damaged. Careful here, they are delicate electrically. Do not use pliers
or any tools to tighten the tie wrap, just your hand strength. If it is pulled too
tight, it will cause the black cartridge to lift up.
Tie Wrap Installation
Install Tube Bracket:
4. Clean the housing surface where the bracket will attach with alcohol. Clean the top
edge of housing. Wipe dry with a paper towel or clean cloth. The tube clip on the
bracket should be on the right side. Remove the paper backing from the foam tape
and place the bracket 6 1/2" from the right inside edge of the printer housing, as
shown below.
S a v e
M o n e y
a n d
I m p r o v e
Y o u r
P r i n t i n g
MIS Associates Inc
2901 Auburn Rd
Auburn Hills, MI 48326
800-445-8296
http://www.inksupply.com
Fax: 248-289-6013