Cisco Meraki CW91641-MR Manuel d'installation du matériel - Page 11
Parcourez en ligne ou téléchargez le pdf Manuel d'installation du matériel pour {nom_de_la_catégorie} Cisco Meraki CW91641-MR. Cisco Meraki CW91641-MR 23 pages.
Imprimer la page
4
Installation Instructions
4.1 Choose Your Mounting Location
A good mounting location is important to getting the best performance out of your CW9166I‐MR,
CW9164I‐MR access point. Keep the following in mind:
1. The device should have unobstructed line of sight to most coverage areas. For example, if
installing in an office filled with workspaces divided by mid‐height cubicle walls, installing on the
ceiling or high on a wall would be ideal.
2. Power over Ethernet supports a maximum cable length of 300 ft (100 m).
3. If being used in a mesh deployment, the CW9166I‐MR, CW9164I‐MR should have line of sight to at
least two other Meraki devices. For more detailed instructions regarding access point location
selection, reference the Meraki Network Design Guide
4.2 Install the CW9166I‐MR, CW9164I‐MR
For most mounting scenarios, the CW9166I‐MR, CW9164I‐MR mount plate provides a quick, simple, and
flexible means of mounting your device. The installation should be done in two steps. First, install the mount
plate to your selected location. Then, attach the CW9166I‐MR, CW9164I‐MR to the mount plate.
!!! This equipment is only suitable for mounting at heights ≤ 2 m !!!
4.2.1
Attach the Mount Plate
The CW9166I‐MR, CW9164I‐MR mount plate can be used to install your access point in a wide range of
scenarios: wall or solid ceiling, below a drop ceiling, on various electrical junction boxes, or above a drop
ceiling (in the plenum).
The mount plate contains a variety of hole patterns that are customized for each installation scenario. The
mounting template (included inbox with mount plate) should be used to drill holes for wall mounts and also
to identify the correct hole patterns in the mount plate that should be used for each type of mount.
The following images also show the hole patterns that should be used for each type of mount:
11
(meraki.com/library/product).