Cisco Meraki MR76 Manuel d'installation - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Cisco Meraki MR76. Cisco Meraki MR76 27 pages.

Imprimer la page

LED indicator

Your MR76 is equipped with a multi-color LED light on the bottom edge of the unit to convey information about system functionality and performance:

• Orange - AP is booting (permanent Orange suggests hardware issue)

• Rainbow - AP is initializing/scanning

• Blinking Blue - AP is upgrading

• Green - AP in Gateway mode with no clients

• Blue - AP in Gateway mode with clients

• Blinking Orange - AP can't find uplink

The MR76 may be operated in "Run Dark" mode for additional security and to reduce the visibility of the access point. In this mode, the LED will not be

illuminated. This mode may be enabled through the Meraki dashboard.

Ethernet Port

The MR76 features one Ethernet ports:

This accepts 802.3af power and should be used as the primary uplink to your LAN/WAN.

N-Type antenna attachment ports (4x)

2x N-Type antenna ports are located at the top of the MR76 and 2x are located at the bottom of the MR76. The 4 antenna ports are connected to 2.4 GHz and

5 GHz client serving radios respectively. Please see the markings on the AP to verify 2.4GHz and 5GHz ports. In order to ensure the highest performance,

ensure antennas connected to the 4 ports have overlapping coverage areas.

Mount plate attachment slots

The mounting slots located on the rear shell of the MR76 marry to the 4 mounting posts on the mounting plate, securely fastening the MR76 to the mounting

plate.

Factory reset button

The factory reset button is located in a small pin-sized hole just above the PoE Ethernet port of the MR76. If the button is pressed and held for at least ﬁve

seconds and then released, the MR76 will reboot and be restored to its original factory settings by deleting all configuration information stored on the unit.

The Vent

The vent allows pressure equalization between the interior and the environment. This prevents internal condensation and maintains a waterproof seal.