Cisco WAP371 Manuel de démarrage rapide - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} Cisco WAP371. Cisco WAP371 15 pages. Reboot and reset to factory default settings
Également pour Cisco WAP371 : Manuel de démarrage rapide (38 pages), Manuel (5 pages), Manuel (4 pages)

Imprimer la page

Insecure mounting might damage the device or cause injury.

ARNING

Cisco is not responsible for damages incurred by insecure wall

or ceiling mounting.

To mount the Cisco WAP 371 device to a wall or ceiling:

Determine where you want to mount the device. Verify that the

TEP

surface is smooth, flat, dry, and sturdy.

Drill two pilot holes into the surface 2.75 inches (70 mm) apart for

TEP

your Cisco WAP device.

Insert a screw into each hole, leaving a gap between the surface

TEP

and the base of the screw head.

Place the upper slots of the bracket over the screws, adjust the

TEP

screws accordingly, and slide the bracket down until the screws fit

snugly into the slots.

Using the bracket as a template, drill two more holes for the lower

TEP

screws.

Insert a screw into each lower hole.

TEP

Slide the WAP device into the bracket, placing the cable through

TEP

the break-out tab found in the back of the bracket.

Connecting the Cisco WAP371 Wireless-

AC/N Dual Radio Access Point with Single

Point Setup

The default configuration of the device has the Wi-Fi radio turned off. You

must perform the initial configuration using a wired Ethernet connection. To

connect the device to the wired network:

Connect the Ethernet cable to the Ethernet port of a switch, a router,

TEP

or a PC.

Connect the other end of the network Ethernet cable to the

TEP

Ethernet port of the wireless access point.

Cisco WAP371 Wireless Access Point