Cisco MCU 5300 series Manuel d'installation - Page 8

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Cisco MCU 5300 series. Cisco MCU 5300 series 14 pages. Telepresence

Imprimer la page

(Optional) Clustering MCU 53x0s

Before you start

Up to two MCU 53x0s can be clustered to increase capacity. One of the MCU 53x0s acts as the master unit

and the second as a slave, and the cluster will provide the sum of the conferencing capacity of the individual

units.

For example, if you cluster two MCU 5320s, which each support up to ten 1080p participants, your cluster

will support up to twenty 1080p participants.

You may combine an MCU 5310 with an MCU 5320 in the cluster, provided that they are running identical

software versions. In this case, the MCU 5320 must be configured as the master.

You will also need a Cisco TelePresence MCU 5300 Series Stacking Cable which must be ordered

separately. Please contact your reseller or go to www.cisco.com.

Task 1: Connect the devices using the stacking cable

1. If your stacking cable has protective tapes or caps on the ends, remove them so that the metal conductors

are visible within the plug.

2. Plug the ends of the stacking cable into the Link sockets on the rear of the MCU 53x0s. Check the

orientation of the plug when inserting it into the Link socket.

3. To remove the cable, pull the release mechanism to detach the plug. Do not pull directly on the plug.

Task 2: Configure the master device

One of the MCU 53x0s must be configured as the master device and the other as a slave.

1. Log in to the web interface of the device you have selected as the master.

In a mixed cluster, you must use the MCU 5320 as the master.

2. Go to

Settings > Media

3. Select Master from the Cluster mode drop down menu.

4. Click Apply changes.

5. Click OK to restart the device and apply the changes.

6. Go to

Status > Cluster

Task 3: Configure the slave device

1. Log in to the web interface of the other device.

2. Go to

Settings > Media

3. Select Slave from the Cluster mode drop down menu.

4. Click Apply changes.

5. Click OK to restart the device and apply the changes.

6. Go to

Status > Cluster

Cisco TelePresence MCU 5300 Series Installation Guide

ports.

to confirm that the device has been correctly configured as the master.

ports.

to confirm that the device has been correctly configured as the slave.

Page 8 of 14