Argo DD Manuel d'instructions d'installation - Page 5
Parcourez en ligne ou téléchargez le pdf Manuel d'instructions d'installation pour {nom_de_la_catégorie} Argo DD. Argo DD 16 pages. Air conditioner without outdoor unit
Imprimer la page
2.2 - SIGNALING LAMPS
2
1. Receiver : it receives signals transmitted from the
remote control.
2. TIMER lamp: This lamp lights up when the air
conditioner is being controlled by the timer.
3. STANDBY lamp: This lamp lights up when the air
conditioner is waiting to start or the desired temperature
has been reached.
4. OPERATION lamp: This lamp lights up during
operation.
2.3 - ACCESSORIES SUPPLIED WITH THE UNIT
1. PLASTIC SHEET (2pcs.)
2. ExTERNAL GRILLES (2pcs.)
3. INTERNAL GRILLES (2pcs.)
4. TENSION BARS (2pcs.)
5. FULL SCALE DIAGRAM (1pcs.)
6. RAWL PLUGS + SCREWS
7. REMOTE CONTROL UNIT (1pcs.)
8. BATTERIES FOR REMOTE CONTROL (2pcs.)
9. GASKETS (4pcs.)
10. HANGING BRACKET
11. CONDENSATE DRAINAGE PIPE WITH
INSULATION
12. JUMPER FOR PCB (4pz.)
7
4
3
1
8
WARNING
The OFF position does not disconnect the power. Use
the main power switch to turn off power completely.
NOTES
It is possible to set the air conditioner in order to let
l
the OPERATION, TIMER and STANDBY lamps always
OFF, even during operation.
Press contemporary the IFEEL and FAN buttons on
the remote control unit for more then 5 seconds.
Repeat the same procedure to set again the normal
operation conditions.
In case of troubleshooting the air conditioner
l
diagnostic system activates the lamps accordingly,
even if they are set to OFF. See paragraph
TROUBLESHOOTING for further details.
When the air conditioner is OFF lights are off to
l
reduce power consumption.
5
2
9
5
10
11
1
12
3
6
EN
4