Cisco Telepresence MX200 Manuel de démarrage - Page 24

Parcourez en ligne ou téléchargez le pdf Manuel de démarrage pour {nom_de_la_catégorie} Cisco Telepresence MX200. Cisco Telepresence MX200 35 pages. Table stand
Également pour Cisco Telepresence MX200 : Manuel de l'utilisateur (44 pages), Manuel de démarrage (42 pages), Manuel de référence rapide (2 pages), Manuel de démarrage rapide (12 pages), Manuel de référence rapide (2 pages), Manuel de dépannage (37 pages), Manuel d'installation (6 pages), Manuel de démarrage (46 pages)

Imprimer la page
Cisco Telepresence MX200 Manuel de démarrage
Cisco TelePresence Systems
GettinG started Guide
Table of contents
Introduction
remote control and on-screen menu
Setting date, time and location
When setting up your video conference system, you
should check that the date and time settings are correct.
Among other things this information is used to time stamp
messages transmitted to gatekeepers and other network
elements.
The time and date is shown in the top right corner of the
main display.
Save the new value when you change a setting
• Drop down list selection: Navigate to the correct
value and press the
OK
( )
key to save, or press
the left arrow key
to leave without saving.
• Text entry in an input field: Enter the text, navigate
to
Ok/Save
to save the change, or navigate to
Cancel
to leave without saving; then press
OK
( )
to confirm.
D14639.04 Video Systems Getting Started Guide (TC4.2) | 2011 JULY | © 2011 Cisco Systems, Inc. All rights reserved.
User interfaces
Configuration
Configuration
1. Go to
Home > Settings > Date and
2. Select
24 hours
or
12 hours (am/pm)
drop down list as you prefer.
3. Select day.month.year,
month.day.year
in the
Date format
drop down list as you prefer.
4. Select your time zone in the
Time zone
5. Select Auto,
Manual
or
Off
in the
list as you prefer.
1
If you select Manual, also enter the
in the corresponding input field.
If you select
Off,
also select the correct value for Day,
Month,
Year
and
Time
in the corresponding drop down
lists.
6. Press
Home
(
)
to exit.
NTP mode:
1
Auto:
The time is regularly updated using an NTP server. The
NTP server address is automatically obtained from the
network (DHCP).
Manual: The time is regularly updated using an NTP server. You
must manually enter the NTP server address.
Off:
You must set the time manually. The time will not be
updated automatically.
Appendices
Time.
in the
Time format
or
year.month.day
drop down list.
NTP mode
drop down
NTP server
address
24
www.cisco.com