DigiTech VTP1 Manuel du propriétaire - Page 2

Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} DigiTech VTP1. DigiTech VTP1 15 pages. Dual vacuum-tube preamp/eq/converter

Imprimer la page

The symbols shown above are internationally accepted symbols that warn of

potential hazards with electrical products. The lightning flash with arrowpoint

in an equilateral triangle means that there are dangerous voltages present with-

in the unit. The exclamation point in an equilateral triangle indicates that it is

necessary for the user to refer to the owner's manual.

These symbols warn that there are no user serviceable parts inside the unit.

Do not open the unit. Do not attempt to service the unit yourself. Refer all

servicing to qualified personnel. Opening the chassis for any reason will void

the manufacturer's warranty. Do not get the unit wet. If liquid is spilled on

the unit, shut it off immediately and take it to a dealer for service. Disconnect

the unit during storms to prevent damage.

U.K. MAINS PLUG WARNING

A moulded mains plug that has been cut off from the cord is unsafe. Discard

the mains plug at a suitable disposal facility. NEVER UNDER ANY CIR-

CUMSTANCES SHOULD YOU INSERT A DAMAGED OR CUT MAINS

PLUG INTO A 13 AMP POWER SOCKET. Do not use the mains plug with-

out the fuse cover in place. Replacement fuse covers can be obtained from

your local retailer. Replacement fuses are 13 amps and MUST be ASTA

approved to BS1362.

ELECTROMAGNETIC

COMPATIBILITY

This unit conforms to the Product Specifications noted on the Declaration of

Conformity. Operation is subject to the following two conditions:

• this device may not cause harmful interference, and

• this device must accept any interference received, including

interference that may cause undesired operation. Operation of

this unit within significant electromagnetic fields should be

avoided.

• use only shielded interconnecting cables.

FCC COMPLIANCE

This equipment has been tested and found to comply with the limits for a Class

B digital device, pursuant to Part 15 of the FCC Rules. These limits are

designed to provide reasonable protection against harmful interference in a res-

idential installation. This equipment generates, uses and can radiate radio fre-

quency energy and, if not installed and used in acordance with the instructions,

may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this

equipment does cause harmful interference to radio or television reception,

which can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the following

measures:

• Reorient or relocate the receiving antenna

• Increase the separation between the equipment and receiver that may cause

undesired operation.

• Connect the equipment into an outlet on a circuit different from that to which

the receiver is connected

• Consult the dealer or an experienced radio/TV technician for help.

DECLARATION OF CONFORMITY

Manufacturer's Name:

IVL Technologies Ltd.

per DigiTech specifications

Manufacturer's Address:

#108-721 Vanalman Ave

Victoria, B.C.

Canada V8Z 3B6

declares that the products:

DigiTech VTP-1 Dual Vacuum Tube Preamp

conform to the following product specifications:

Safety:

EN 60065

IEC 65 (1993)

Amendment 1 (1987)

Amendment 2 (1989)

Amendment 3 (1992)

EMC:

EN 55022 (1987):

CISPR 22 (1993) Class B

EN 50082-1 (1992)

WARNING

FOR YOUR PROTECTION, PLEASE READ THE

FOLLOWING:

Water and Moisture: Appliance should not be used near water (e.g. near a

bathtub, washbowl, kitchen sink, laundry tub, in a wet basement, or near a

swimming pool, etc). Care should be taken so that objects do not fall and liq-

uids are not spilled into the enclosure through openings.

POWER SOURCES: The appliance should be connected to a power supply

only of the type described in the operating instructions or as marked on the

appliance.

GROUNDING OR POLARIZATION: Precautions should be taken so that the

grounding or polarization means of an appliance is not defeated.

POWER CORD PROTECTION: Power supply cords should be routed so that

they are not likely to be walked on or pinched by items placed upon or against

them, paying particular attention to cords at plugs, convenience receptacles,

and the point where they exit from the appliance.

SERVICING: To reduce the risk of fire or electric shock, the user should not

attempt to service the appliance beyond that described in the operating instruc-

tions. All other servicing should be referred to qualified service personnel.

CAUTION: To reduce the risk of fire replace only with same type fuse.

ATTENTION: Utiliser un fusible de recharge de même type.

CAUTION: To reduce the risk of fire replace LAMP with manufacturers rec-

ommended part ( Refer to service literature)

SAFETY INSTRUCTIONS

Notice For Customers If Your Unit Is Equipped With A Power Cord.

WARNING: THIS APPLIANCE MUST BE EARTHED.

The cores in the mains lead are coloured in accordance with the following

code:

GREEN and YELLOW - Earth

As colours of the cores in the mains lead of this appliance may not correspond

with the coloured markings identifying the terminals in your plug, proceed as

follows:

• The core which is coloured green and yellow must be con-

nected to the terminal in the plug marked with the letter E, or

with the earth symbol, or coloured green, or green and yellow.

• The core which is coloured blue must be connected to the ter-

minal marked N or coloured black.

• The core which is coloured brown must be connected to the

terminal marked L or coloured red.

This equipment may require the use of a different line cord, attachment plug,

or both, depending on the available power source at installation. Connect this

equipment only to the power source indicated on the equipment rear panel. If

the attachment plug needs to be changed, refer servicing to qualified service

personnel who should refer to the table below. The green/yellow wire shall be

connected directly to the unit's chassis.

WARNING: If the ground is defeated, certain fault conditions in the unit or in

the system to which it is connected can result in full line voltage between

chassis and earth ground. Severe injury or death can then result if the chassis

and earth ground are touched simultaneously.

Supplementary Information:

The product herewith complies with the requirements of the Low Voltage Directive

73/23/EEC and the EMC Directive 89/336/EEC (1989) as ammended by the CE

Marking Directive 93/68/EEC (1993).

IVL Technologies Ltd.

#108-721 Vanalman Ave.

Victoria, B.C.

Canada V8Z 3B6

March 4, 1996Peter George

Vice President of Engineering

European Contact: Your local DigiTech Sales and Service Office or

International Sales Office

3 Overlook Drive Unit #4

Amherst, New Hampshire 03031, USA Tel (603) 672-4244 Fax (603) 672 4246

BLUE - Neutral

BROWN - Live