Cisco TelePresence VX Clinical Assistant Manuel d'installation et d'utilisation - Page 11

Parcourez en ligne ou téléchargez le pdf Manuel d'installation et d'utilisation pour {nom_de_la_catégorie} Cisco TelePresence VX Clinical Assistant. Cisco TelePresence VX Clinical Assistant 33 pages. Mobile video system

Imprimer la page

Installing the Rechargeable Battery

The system's rechargeable battery is disconnected for

shipping and must be connected for proper operation.

NOTE: Ensure AC Power is not connected to the cart

when installing the battery.

1. Remove the ACCESS PANEL on the lower column

by unscrewing the THUMBSCREW (1) near the top

of the plate.

2. Remove the WING NUT (1) holding the BASE PLATE

in place.

3. Remove the BASE PLATE by gently pulling the plate

forward and then up.

4. Locate the YELLOW BATTERY CONNECTOR that

extends from the battery and plug into the POWER

SUPPLY UNIT.

5. Replace the BASE PLATE and the ACCESS PANEL.

If the BATTERY has enough charge, then the VX Clinical

Assistant is ready to be configured and begin making

calls.

If the BATTERY does not have enough charge, provide

power by plugging the system into an appropriate

outlet (120V or 240V) -- this charges the BATTERY

while powering the system with AC power.

It is recommended that the unit is initially charged 4-6

hours or until the batter meter indicates a full charge.

Make sure the display is ON if it has not turned on

automatically.

141299.21 Cisco TelePresence VX Clinical Assistant

ACCESS PANEL

NOTE: Providing power to the system via the AC

power cord will automatically switch the system from

battery power to AC power; the battery power will

shut off and will begin to charge from the AC power.

Ensure the POWER SWITCH is in the OFF position

when connecting to AC power, and then switch to the

ON position to use AC power and charge the battery.

BATTERY CONNECTOR

BASE PLATE

50A FUSE

(Field Replaceable -- see

Troubleshooting Section)

BATTERY MAINTENANCE: To insure maximum longevity

of the battery, the VX Clinical Assistant should periodi-

cally be operated on battery power until the "Low Bat-

tery " warning comes on. Once the warning sounds the

system should be reconnected to an AC power source

until the battery is fully charged.