Argo SDIAS8DC Manuel d'utilisation - Page 3

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Argo SDIAS8DC. Argo SDIAS8DC 17 pages. Split air conditioner system
Également pour Argo SDIAS8DC : Manuel d'utilisation (15 pages), Manuel d'instructions d'installation (19 pages)

Imprimer la page

NAME OF PARTS AND OPERATION SELECTOR SWITCH

7 8 9

1. Remote control unit.

2. Remote control sensor: Detects the room temperature

around the remote control unit, the air conditioner is

controlled accordingly.

3. Air outlet: Conditioned air is blown out of the air

conditioner through the air outlet.

4. Air intake: Air from the room is drawn into this section

and passes through air filter which removes dust.

5. Remote control receiver: This section picks up infrared

signals from the remote control unit (Transmitter).

6. Operation selector (without remote control): Push

the button to walk through the operation modes (OFF,

COOL and HEAT)

WARNING

The OFF selection does not disconnect the power. Use

the main power switch to turn off power completely.

7. OPERATION lamp: This lamp lights up during

operation.

It blinks once to announce that the remote control

signal has been received and stored.

8. STANDBY lamp: This lamp lights up when the air

conditioner is connected to the power and ready to

receive the remote control command.

9. TIMER lamp: This lamp lights up when the system is

being controlled by the timer.

10. Air filter.

NOTA

When the unit receives a signal from the remote

controller, all the three lamps (OPERATION, TIMER

and STANDBY) light up for a moment to indicate the

correct signal reception.

OFF LAMPS FUNTION

It is possible to set the air conditioner in order to let the

OPERATION, TIMER and STANDBY lamps always OFF,

even during operation. (See Light)

In case of troubleshooting the air conditioner diagnostic

system activates the lamps accordingly, even if they are

set to OFF. See paragraph TROUBLESHOOTING for

further details.

If the air conditioner is powered, but the lamps are off, try

to activate them pressing the Light button.