Cisco 2610 - Router - EN Fiche technique - Page 4

Parcourez en ligne ou téléchargez le pdf Fiche technique pour {nom_de_la_catégorie} Cisco 2610 - Router - EN. Cisco 2610 - Router - EN 8 pages. Cisco 2610: quick start
Également pour Cisco 2610 - Router - EN : Manuel de démarrage rapide (19 pages)

Feature
Alarm Detection
Relevant Management Information
Base (MIB) Support
Remote Management
Signaling Debugging

HARDWARE SPECIFICATIONS

Table 4 shows the hardware specifications for the Cisco E1/T1 ISDN PRI Network Module.
Table 4.
Hardware Specifications for the Cisco E1/T1 ISDN PRI Network Module
Feature
Dimensions (H x W x D)
Operating Temperature
Nonoperating Temperature
Relative Humidity
LEDs
Important notices, privacy statements, and trademarks of Cisco Systems, Inc. can be found on cisco.com.
Description
Controller local loopback
Controller remote loopback
CSU loopback modes for T1 CSU
Data terminal equipment (DTE) loopback
Network loopback
Payload loopback
V.54
Yellow Alarm—Receive/Send from/to network
Blue Alarm—Receive alarm indication signal (AIS) from network
Red Alarm—Loss of network signal
RFC1406-MIB
CISCO-ICSUDSU-MIB
Supported by Cisco WAN Access Performance Management System (WAPMS)
Cisco Intelligence Engine (IE2100)
CiscoWorks
CAS debugs
ISDN Q.921 and Q.931 decode
All other previously existing applicable Cisco IOS debugs
Description
1.55 x 7.10 x 7.2 inches
3.9 x 18.0 x 18.3 centimeters
32 to 104° F (0 to 40° C)
–40 to 185° F (–40 to 85° C)
5-95% non-condensing
LEDs per port
T1: T1 mode selected
E1-BAL: E1 balanced mode selected
E1-UNBAL: E1 unbalanced mode selected
CD: Carrier detect
LP: Loop condition present
RA: Remote alarm detected
LA: Local alarm detected
© 2005 Cisco Systems, Inc. All rights reserved.
Page 4 of 8