Cisco 2800 Series Configuration - Page 6

Parcourez en ligne ou téléchargez le pdf Configuration pour {nom_de_la_catégorie} Cisco 2800 Series. Cisco 2800 Series 32 pages. Cisco ios software configuration
Également pour Cisco 2800 Series : Manuel de démarrage rapide (13 pages), Fiche technique (8 pages), Manuel de démarrage rapide (47 pages), Note d'application (41 pages), Manuel de démarrage rapide (45 pages), Configuration (10 pages), Vue d'ensemble (27 pages), Fiche technique (5 pages), Fiche technique (20 pages)

Cisco 2800 Series Configuration
How to Configure Radio Settings on an Access Point
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Router> enable
Step 2
configure terminal
Example:
Router# configure terminal
Step 3
interface dot11Radio interface
Example:
Router(config)# interface dot11Radio 0/3/0
Step 4
speed {data-rates | default | ofdm-throughput |
range | throughput}
Example:
Router(config-if)# speed throughput
Step 5
end
Example:
Router(config-if)# end
Step 6
copy running-config startup-config
Example:
Router# copy running-config startup-config

Configuring Radio and Client Device Power Levels on an Access Point

Perform this task to set the transmit power on your AP and the power level on client devices that
associate to the access point.
When a client device associates to the access point, the AP sends the maximum power level setting to
the client.
SUMMARY STEPS
1.
2.
3.
6
enable
configure terminal
interface dot11Radio interface
Configuring Radio Settings on an Access Point
Purpose
Enables privileged EXEC mode.
Enter your password if prompted.
Enters global configuration mode.
Enters configuration mode for the radio interface.
The interface argument is in module/slot/port format,
except for the Cisco 800 series and Cisco 1800 series
fixed-configuration routers, where the interface
argument is either 0 or 1.
The 2.4-GHz radio is port 0, and the 5-GHz radio is
port 1.
Configures the data rates supported by the access point.
Use the no form of the speed command to disable data
rates. When you use the no form of the command, all
data rates are disabled except the rates you name in the
command.
Returns to privileged EXEC mode.
(Optional) Saves your entries in the configuration file.