3Com 4200G Series Manuel d'installation - Page 2

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} 3Com 4200G Series. 3Com 4200G Series 4 pages. 3com switch 4200g gigabit family
Également pour 3Com 4200G Series : Manuel du produit (13 pages), Manuel du produit (15 pages), Manuel du produit (15 pages), Fiche technique (8 pages), Fiche technique (8 pages)

Imprimer la page

(1): Switch

(3): XFP interface module

Figure 3 Installing an XFP interface module

Note: (1) Store the filler panel for future use.

(2) When tightening the fastening screws at both sides of the

optional module with a screwdriver or an electric screwdriver,

make sure that the torque is not bigger than 0.4 N-m.

1.3 Removal

Step 1: Put on an ESD-preventive wrist strap and verify it is properly

grounded.

Step 2: Loosen the fastening screws at both sides of the XFP interface

module using a screwdriver.

Step 3: Pull the XFP interface module towards you, until it completely

comes out of the switch chassis.

Note: When installing or removing an optional interface module, pay

attention to the following points:

(1) Do not use too much force in the operation, and do not

touch the surface-mounted components directly with your

hands.

(2) After removing an optional module, if no new module is to

be installed, install the filler panel as soon as possible to

prevent dust and ensure the normal ventilation in the switch.

(3)

(4)

(2)

(1)

(2): Optional module slot

(4): Push-in direction