Cisco 3020 - Cisco Catalyst Blade Switch Manuel d'installation - Page 12

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Cisco 3020 - Cisco Catalyst Blade Switch. Cisco 3020 - Cisco Catalyst Blade Switch 21 pages. Release notes for the cisco catalyst blade switch 3020 for hp, ciscoã‚â iosã‚â releaseã‚â 12.2(44)se
Également pour Cisco 3020 - Cisco Catalyst Blade Switch : Manuel de démarrage (37 pages), Manuel de démarrage (31 pages), Quickspecs (12 pages), Note de mise à jour (41 pages), Note de mise à jour (27 pages), Note de mise à jour (23 pages), Note de mise à jour (21 pages)

Imprimer la page

Cisco 3020 - Cisco Catalyst Blade Switch Manuel d'installation

Running Express Setup

The Express Setup home page appears. (See

Figure 2-7

Step 11

Go to

using the Express Setup screen of the Device Manager.

Using the Onboard Administrator to Assign an IP Address to the Switch Module

fa0 Interface

For the switch module to obtain an IP address for the fa0 interface through the Onboard Administrator,

these conditions must be met:

•

See the Onboard Administrator user guide at

Note

more information about configuring and using the Onboard Administrator.

After you install the switch module in the interconnect module bay, after approximately 2 minutes, the

switch module automatically obtains an IP address for its fa0 interface through the Onboard

Administrator. This method of obtaining an IP address occurs if a DCHP server is configured on the same

network, or if the Onboard Administrator is configured as a DHCP server. If you prefer to use Express

Setup to assign the switch module IP address to the VLAN 1 interface, you must start the Express Setup

steps immediately after you install the switch module.

After you have installed the switch module (see the

section on page

that runs automatically to ensure that the switch module functions properly.

Cisco Catalyst Blade Switch 3020 for HP Hardware Installation Guide

2-12

Express Setup Page

"Completing the Express Setup Fields" section on page 2-14

The blade server is powered on and connected to the network.

Basic configuration of the Onboard Administrator is completed, and you have the username and

password for the Onboard Administrator.

A DHCP server is configured on the network segment to which the blade server is connected, or the

Onboard Administrator is configured to run as a DHCP server.

2-6), it powers on. As it powers on, the switch module begins the POST, a series of tests

Figure

2-7.)

to finish setting up the switch module

http://www.hp.com/go/bladesystem/documentation

"Installing the Switch Module in the Blade Server"

Chapter 2

Switch Installation

for

OL-8914-02