Cisco 3140 Pour commencer - Page 28

Parcourez en ligne ou téléchargez le pdf Pour commencer pour {nom_de_la_catégorie} Cisco 3140. Cisco 3140 42 pages.
Également pour Cisco 3140 : Manuel (42 pages)

Imprimer la page

Default Configuration Prior to Initial Setup

Setting

Outside interface IP address.

Default Interfaces by Device Model

You cannot select different inside and outside interfaces during initial configuration. To change the interface

assignments after configuration, edit the interface and DHCP settings. You must remove an interface from

the bridge group before you can configure it as a non-switched interface.

FTD device

Firepower 1010

Firepower 1120, 1140, 1150

Firepower 2100 series

Secure Firewall 3100 series

Firepower 4100 series

Firepower 9300 appliance

FTDv

ISA 3000

Getting Started

Default

IPv4: Obtained through DHCP from

Internet Service Provider (ISP) or upstream

router.

IPv6: Autoconfiguration.

Firepower 4100/9300: Data interfaces are

not pre-configured.

ISA 3000: BVI1 IP address is not

preconfigured. BVI1 includes all inside and

outside interfaces.

Outside Interface

Ethernet1/1

Data interfaces are not pre-configured.

GigabitEthernet0/0

GigabitEthernet1/1 and GigabitEthernet1/3

GigabitEthernet1/1 (outside1) and 1/2

(inside1), and GigabitEthernet1/3 (outside2)

and 1/4 (inside2) (non-fiber models only)

are configured as Hardware Bypass pairs.

All inside and outside interfaces are part of

BVI1.

Can be changed during initial

configuration?

Yes.

Inside Interface

VLAN1, which includes all other switch

ports except the outside interface, which is

a physical firewall interface.

Ethernet1/2

Data interfaces are not pre-configured.

GigabitEthernet0/1

GigabitEthernet1/2 and GigabitEthernet1/4

Getting Started