Cisco 3700 series Fiche technique - Page 4
Parcourez en ligne ou téléchargez le pdf Fiche technique pour {nom_de_la_catégorie} Cisco 3700 series. Cisco 3700 series 8 pages. Siemens hipath 4000 release 1 and siemens hicom 330e release 3.1 to cisco ios voice gateway using e1 qsig with h.323
Également pour Cisco 3700 series : Installation et formatage (34 pages), Instructions de mise à niveau (30 pages), Note d'application (41 pages), Manuel d'installation (12 pages)
Imprimer la page
Feature
Alarm Detection
Relevant Management Information
Base (MIB) Support
Remote Management
Signaling Debugging
HARDWARE SPECIFICATIONS
Table 4 shows the hardware specifications for the Cisco E1/T1 ISDN PRI Network Module.
Table 4.
Hardware Specifications for the Cisco E1/T1 ISDN PRI Network Module
Feature
Dimensions (H x W x D)
Operating Temperature
Nonoperating Temperature
Relative Humidity
LEDs
Important notices, privacy statements, and trademarks of Cisco Systems, Inc. can be found on cisco.com.
Description
•
Controller local loopback
•
Controller remote loopback
CSU loopback modes for T1 CSU
•
Data terminal equipment (DTE) loopback
•
Network loopback
•
Payload loopback
•
V.54
•
Yellow Alarm—Receive/Send from/to network
•
Blue Alarm—Receive alarm indication signal (AIS) from network
•
Red Alarm—Loss of network signal
•
RFC1406-MIB
•
CISCO-ICSUDSU-MIB
•
Supported by Cisco WAN Access Performance Management System (WAPMS)
•
Cisco Intelligence Engine (IE2100)
•
CiscoWorks
•
CAS debugs
•
ISDN Q.921 and Q.931 decode
•
All other previously existing applicable Cisco IOS debugs
Description
•
1.55 x 7.10 x 7.2 inches
•
3.9 x 18.0 x 18.3 centimeters
32 to 104° F (0 to 40° C)
–40 to 185° F (–40 to 85° C)
5-95% non-condensing
LEDs per port
•
T1: T1 mode selected
•
E1-BAL: E1 balanced mode selected
•
E1-UNBAL: E1 unbalanced mode selected
•
CD: Carrier detect
•
LP: Loop condition present
•
RA: Remote alarm detected
•
LA: Local alarm detected
© 2005 Cisco Systems, Inc. All rights reserved.
Page 4 of 8