Cablematic BLE-485C Manuel de l'utilisateur - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Cablematic BLE-485C. Cablematic BLE-485C 8 pages. Bluetooth v4.2 ble rs-422/485 serial adapter

Imprimer la page
BLE RS-485 Serial Adapter
DEFAULT=
Y
DFU=
Y
ECHO=
N
(Default)
Y
?
FLOW=
(Default)
N
Y
?
NAME=
(Default)
BLE232
xx....xx
R
?
PARITY=
(Default)
N
O
E
?
PIN=
(Default)
123456
xx....xx
?
PROMPT=
(Default)
Y
N
?
STOP=
This command is used to restore the default settings and originate a
warm start.
Restore the default settings (e.g. 19200 bps).
The command will re-start the system for 1 second.
Device Firmware Upgrade via PC software. OTA (Over the air) is
available to upgrade the firmware by APP
This command is used to specify whether the adaptor echoes
characters received from the UART back to the DTE/DCE.
Command characters received from the UART are not echoed back to
the DTE/DCE.
Command characters received from the UART are echoed back to the
DTE/DCE.
Inquire the current setting.
This command enable or disable flow control signals (CTS/RTS) of the
UART port. Note, the setting is not affected by DEFAULT.
The command will need 1 second delay.
Disable flow control.
Enable flow control.
Inquire the current setting
This command is used to specify a device name for the adaptor.
You can specify a friendly name using 0 to 9, A to Z, a to z, space and
–, which are all valid characters. Note that "first space or -, last space or
– isn't permitted". The default name is "Serial Adaptor".
Default device name
"xx....xx" is a character string with the length from 2 to 30.
Restore the default settings name="BLE Serial".
Inquire the name of the local adaptor.
This command is used to specify parity bit setting of COM port.
The command will need 200 ms delay.
None parity bit
Odd parity
Even parity
Inquire the current setting.
This command is used to specify a PIN code. The default PIN is
"123456". Paired adaptors should have a same PIN. This command is
used to specify a PIN.
"xx....xx" is a 6 number 0~9
Inquire the current PIN.
The command is used to decide whether result messages are prompted
when Setup commands are executed. The result messages are:
OK/ERROR for command execution.
Prompt result messages.
Not prompt result messages.
Inquire the current setting.
This command is used to specify one or two stop bits of COM port.
6
User Manual V1.3