ACU-RITE 06008RM Manuel d'instruction - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} ACU-RITE 06008RM. ACU-RITE 06008RM 8 pages. 3-in-1 sensor

3-in-1 Sensor Installation Guidelines

INSTALLATION HEIGHT

(higher is better for wind measurement) in an open area. Secure to fence post, 2"x4"

wood, 3/4" pole, etc. (not included)

LEVEL INSTALLATION

accurate wind measurement.

Top or Side Mount

1. Insert the mounting base into the

hole on the bottom of the sensor.

2. Use one of the screws included

in the hardware bag to fasten

the lower sensor housing to the

mounting base.

3. Fasten mounting base to a post or

railing using 2 screws.

Pole Mount

1. Insert pole (we recommend 3/4" schedule

40 PVC / 25.8 mm O.D., not included)

or similar item all the way into the hole on

the bottom of the sensor. Note: Mounting

base is not used.

2. Use one of the screws included in the

hardware bag to fasten the lower sensor

housing securely to the pole.

The 3-in-1 sensor is now ready to use.

Clear Data Collected During Installation

When installation is complete, clear erroneous data from companion unit (not

included). Please refer to the companion unit's instructions for details.

Basic Setup is Complete

The 3-in-1 sensor will now synchronize. It may take a few minutes for synchronization

to complete.

Mount the sensor at least 5 feet (1.5 meters) off the ground

Use a bubble level (not included) to ensure level installation for

Top Mount

Side Mount

Pole Mount

Do not install during

electrical storms.

Do not place pole

or sensor near

electrical lines or

electrical equipment.