Cisco 5400 Installation et mise à niveau - Page 7
Parcourez en ligne ou téléchargez le pdf Installation et mise à niveau pour {nom_de_la_catégorie} Cisco 5400. Cisco 5400 8 pages. Frus
Également pour Cisco 5400 : Préparation de l'installation (6 pages)
Imprimer la page
Installing and Upgrading FRUs
Installing and Removing a NIM
These are the steps to install a NIM:
• Locate the NIM slot on the front panel.
• Loosen the screws to open the slot cover.
• Insert the NIM into the slot.
• Tighten the screws to secure the NIM in the slot.
These are the steps to remove a NIM:
• If the NIM is up and running, issue the following command to shut down the NIM gracefully before
• Locate the NIM slot on the front panel.
• Loosen the screws that secure the NIM.
• Gently pull out the NIM from the slot.
ENCS supports hot swap or OIR (Online Insertion and Removal) for NIM. So, you can insert and remove the
NIM when ENCS is running; however, before removing the NIM, ensure that the NIM is shut down gracefully.
Code extract that shows the graceful shutdown of a NIM:
CSR-8#hw-module subslot 0/2 stop
Proceed with stop of module? [confirm]
CSR-8#
CSR-8#
CSR-8#sh platform
Chassis type: ISRV
Slot
--------- ------------------- --------------------- -----------------
0
0/2
R0
F0
removing it:
hw-module subslot slot 0/2 stop
Caution
If you do not shut down the NIM gracefully before removing it, the NIM card
could get damaged.
Type
ISRV
NIM-4G-LTE-NA
ISRV
ISRV
State
Insert time (ago)
ok
16:41:27
stopped
00:00:05
ok, active
16:42:19
ok, active
16:42:19
Installing and Removing a NIM
Installing and Upgrading FRUs
7