Cisco 7507 Manuel de démarrage rapide - Page 8

Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} Cisco 7507. Cisco 7507 44 pages. Air filter and chassis blower replacement
Également pour Cisco 7507 : Manuel d'instructions d'installation (39 pages), Fiche technique (11 pages), Manuel d'instructions de remplacement (21 pages)

Install the Hardware

Secure the Spacers

Step 1

Loosen the 10-32 x 5/8-inch LG Phillips

pan-head screw at the end of the ledge of

the right-side bracket. This screw is the

anchor for the spanner bar.

Step 2

Remove the tape that secures the spanner

bar on the left bracket, and swing the bar

down (see A) over the anchor screw on the

opposite bracket.

Step 3

If the spanner bar does not reach the

opposite bracket, loosen the pan-head

screws to allow more play between the

brackets.

Step 4

Repeat Step 1 through Step 3 to fasten the

remaining spanner bar to its anchor screw.

(See C.)

Step 5

Push the brackets as far apart as possible

before tightening the screws.

Step 6

Use a Number 2 Phillips screwdriver to

tighten the six pan-head screws that

secure the brackets to the rack-mounting

posts, and the two anchor screws that

secure the spanner bars. (See B.)

Step 7

Adjust the brackets if the distance

between them is less than 17.5 inches

(44.45 cm).