Cisco 7507 Manuel d'instructions d'installation - Page 26

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions d'installation pour {nom_de_la_catégorie} Cisco 7507. Cisco 7507 39 pages. Air filter and chassis blower replacement
Également pour Cisco 7507 : Manuel de démarrage rapide (44 pages), Fiche technique (11 pages), Manuel d'instructions de remplacement (21 pages)

Imprimer la page

Installation

Restarting the System

To complete the installation, you will perform a ﬁnal check of all connections, then restart the

system. This procedure is not for new systems; perform this procedure only if you have already

connected the network interfaces and performed the ﬁrst-time startup procedures in the Cisco 7000

Hardware Installation and Maintenance or Cisco 7507 Hardware Installation and Maintenance

publications.

Follow these steps to restart the system and verify that the system restarts successfully:

Step 1

Step 2

Step 3

Step 4

Step 5

Step 6

Step 7

If the power supplies do not start up, or if the system or any interfaces do not initialize properly, refer

to the Cisco 7000 Hardware Installation and Maintenance or Cisco 7507 Hardware Installation and

Maintenance publications for additional information and installation troubleshooting procedures.

If necessary, contact a service representative. (See the following section, "Cisco Information

Online.")

26 Cisco 7000 and Cisco 7507 Rack-Mount Kit Installation Instructions

Check the following components to make sure they are secure:

•

Each interface processor is fully inserted in the slot and all captive installation screws

are tightened.

•

All interface cable connections are secured.

•

Each power supply is fully inserted in the bay, and the captive screw is tightened.

•

All power supply cables are inserted into the power supply and secured with the cable

retention clip.

•

All power cables are connected to a power source.

Ensure that a console terminal is connected to the RP console port and turned on, or that

you have a remote login to the router from another device through a Telnet session. (You

will need to check the startup banner and displays to ensure that the system restarts properly

and that all the interfaces reinitialize in the proper state.)

When you have checked all of the connection points, turn the lower power supply on by

turning the power supply switch clockwise one-quarter turn. The AC power LED on the

lower AC-input power supply (or the input power LED on the DC-input power supply) and

the lower power LED on the front of the chassis should go on.

Listen for the system blower. You should hear it start operating immediately.

After the lower power supply is on, turn the upper power supply on (if one is present) for

redundant power. The AC power LED on the upper AC-input power supply (or the input

power LED on the DC-input power supply) and the upper power LED on the front of the

chassis should go on.

On the console terminal, verify that the console displays the system banner and that the

system and all interfaces initialize successfully.

If you try to turn on a power supply and the switch resists, the power supply probably is not

fully inserted into the bay. Turn the power switch fully counterclockwise (to O), pull the

power supply out of the bay about two inches, then push the power supply ﬁrmly back into

the slot. Do not slam the supply into the slot; doing so can damage the connectors on the

supply and the backplane. Tighten the captive installation screw before turning on the

switch.