DigiTech Home AR-1885 Manuel de l'utilisateur - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} DigiTech Home AR-1885. DigiTech Home AR-1885 5 pages. With vibrating wrist band

Imprimer la page
Instructions:
Default Settings:
-
Display mode: Hour/Minute/Second
-
Language: English
-
Clock time is January 1, 2012, 0:00
-
The alarm time is 0:00 and the alarm is disabled.
-
The time format is 24 hour (DCF) or 12 hour (WWVB)
-
The temperature unit is °C (DCF or °F (WWVB).
ALARM and SNOOZE functions:
-
When the alarms 1 or 2 is viewed on the display, press and hold the ALARM button for 2 seconds to
enter the set mode of alarm time. The sequence is Hour—Minute—Alarm mode—Exit
-
Press the UP or DOWN buttons to modify the alarm time. Press and hold the UP or DOWN buttons
for 2 seconds to toggle the selections quickly.
-
When the alarm displays, press UP or DOWN buttons to select alarm modes, it will cycle through
Audio Alarm—Vibration alarm—Audio and Vibration—Disable.
-
Press the ALARM button to enter next set parameter or exit.
-
When the current time is the same as the alarm time, the alarm function will enable and the unit
will sound for 90 seconds, any key except for the SNOOZE button will disable the alarm.
-
When the unit sounds, if the SNOOZE button is pressed, the unit will enter snooze mode for 5
minutes. After 5 minutes the unit will sound again.
-
While the unit is sounding, the icons
Stopping an alarm:
When the alarm is beeping or vibrating on the wrist belt, press any key (except for SNOOZE/LIGHT button)
and it will stop the beeping or vibrating.
RCC Function (DCF & WWVB):
-
The unit receives RCC-Time; it will update the time and display the icon
receiving RCC data via RF.
-
If the unit fails to receive RCC data within 10 minutes, the icon
-
The unit will automatically try to receive RCC data at 3:00, the icon
data; if it has detected an RCC signal, the icons
-
The unit will display the icon
-
RCC activation method:
When powering on or after a reset, the radio-controlled clock will start receiving RCC.
o
Press and hold the UP key for 2 seconds to manually activate RCC reception.
o
RCC will automatically activate at 3:00am. Upon failure of receiving RCC successfully it will
o
automatically try every hour following until 6:00am.
-
During RCC receiving, pressing the UP or SNOOZE buttons will exit from RCC and the icon
indicate that it failed to receive.
-
For WWVB version, received time is adjusted by PMCE time zone and DST setting, as below:
P time zone: RCC time -8
o
M time zone: RCC time-7
o
C time zone: RCC time -6
o
E time zone: RCC time -5
o
Note: If RCC time DST is set and DST is on, then time should be +1
or
or
if the user modifies the time in setting mode.
icons will flash.
will show.
will flash to indicate it is receiving RCC
or
will flash to show signal strength.
after successfully
will show to