Digitek G-Line Pro Manuel d'instructions d'installation - Page 13
Parcourez en ligne ou téléchargez le pdf Manuel d'instructions d'installation pour {nom_de_la_catégorie} Digitek G-Line Pro. Digitek G-Line Pro 14 pages.
Imprimer la pagePrograming Example;
With the alarm dis-armed, lift the seat or open the top-case, if there is no contact switch fitted you will need to
ground the alarm Green/Brown wire.
Turn ignition key to 'ON', the alarm LED will light up for 1 second.
While the alarm LED is ON, simultaneously press the 2 buttons on the alarm remote control. Two beeps will
confirm that the system is in programming mode. The LED will turn ON steady.
Press button 1 on the alarm remote control, a high-tone beep will confirm that acoustic signals have been
enabled.
Press button 1 again, a high-tone beep will confirm that the panic siren has been enabled.
When the last feature is programmed, the system automatically exits the programming procedure. Three low
tone beeps followed by a high tone beep will confirm the end of the procedure. The alarm LED will also turn
OFF.
Turn ignition key 'OFF' and close the seat/top-case or remove the Green/Brown wire from ground and insulate.
NOTE: You can exit the programming procedure at any time by turning ignition key 'OFF'.
Programmed features will automatically be saved while the others will remain unchanged.
This compact alarm system is supplied with two '2-button' remote controls. The remote control has a low battery
charge indicator that gives you early warning to avoid malfunctioning. When the batteries are fully charged, the radio
key LED will show a steady light at the press of a button. If the batteries are low the radio key LED will start blinking
rapidly when the button is pressed.
2.1 – Replacing Remote Control Batteries
Button 1:
Alarm system arming/dis-arming
Panic Alarm
Button 2:
Hazard feature activation
LED
indicator
Button 1
Button 2
13/14
www.digitek-moto.com
Rev05/KM/271113/DigProInst
G-Line 'Pro' Alarm
System