Argo JP 6215CD Manuel d'instruction - Page 14
Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Argo JP 6215CD. Argo JP 6215CD 16 pages.
Imprimer la page
serViCe
Proceed only with routine actions according to the manual. Do not repair or service
machines on your own. Unplug the machine from the circuit and contact seller when one
or more of the following faults occur:
•
liquid gets into the machine
•
machine malfunctions as a result of improper use
•
machine does not work accordingly to the manual
PrOBlem sOlViNG
problems
No operation
No operation after
long time operation
stop at shredding
excess squeaking
and rubbing noise
Paper jam
© arGO s.a.
EN
checklists
The power plug is properly
inserted to main supply?
switch is set at „i" position?
switch at „l" position but power
light off.
Basket at stand but power light
off.
No operation when insert paper?
checked above but no operation
and no power light.
Power lamp is on?
Machine is continuously
shredding for a long time?
Without oiling to the cutting
system periodically.
- squeaking and rubbing noise at
shredding.
- exceeding the shredding
capacity
- The paper is not fed squarely
into the feed opening.
14
solutions
Fully put the power plug to the
outlet.
set switch to „i" position for
operation.
check basket is out of stand.Put
basket back to stand.
Basket should be put into
stand to trigger the safety
interlock switch for operation.
Paper should be inserted to
trigger the sensor at center.
send back to your local service
for repair.
Unplug the machine from
main supply. allow to cool
down to room temperature
and resuming operation.
Unplug the machine from
main supply. allow to cool
down to room temperature
and resuming operation.
Perform the cutter oiling
instruction to lubricate the
cutting system.
set switch to „r" for reverse
running and frees excess
paper. Then set to „i" for cutting
the remainder of paper left in
the cutting system. if serious
jim occurred, send back to
local service for repair.
www.argo.pl