Argo WALLNER HC1601 Manuel d'instruction - Page 12

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Argo WALLNER HC1601. Argo WALLNER HC1601 16 pages.

CAUtION:
1. It is forbidden to place more sheets of paper then the maximum amount indicated by
the producer. If the machine will be overloaded, then please proceed according to the
information given in the "paper jam" section.
2. Never attempt to shred more than one credit card/cD at a time or the shredder will
jam.
3. Never attempt to shred BOTh paper and credit cards/cDs at the same time. Doing so
will damage the shredder.
mOtOR PROtECtION
The shredder is equipped with a motor overload device.
After 60 minutes of continuous work allow the unit to cool for 40 minutes before restarting.
After cooling down, the shredder is ready to re-start to work. It is crucial to avoid the situ-
ation when the thermal fuse will work - this type of usage of the shredder is not proper and
implies machine's overwork.
CUttER OILING INStRUCtIONS
To ensure proper operation and function, periodic oiling of the cutting system is required.
Failure to oil your cutting system could result in reduced sheet capacity performance,
excess noise, paper jams and possibly machine failure. Oil your cutters every 5th or 6th
time you empty the basket, if excess squeaking and rubbing noise is coming from the
machine or if the shredders sheet capacity has diminished. squeeze the lubricant across
the full width of the cutters. Press the reverse button, then press Forward to make shred-
der reverse for 3 seconds. Alternate between forward and reverse at least three times or
until all paper clears the cutters.
CAUtION:
Never use flammable synthetic oil, petroleum based or aerosol lubricants to oil your
cutting system. Use only a vegetable oil based lubricant in a non-aerosol container with
extension nozzle.
BASIC EXPLOItAtION RULES
It is not advised to cut as many shreets as indicated as the maximum capacity of the
shredder. By exploiting the machine at it's top capacity we significantly reduce it's vitality.
Therefore, to maintain a durable and faultless work of the shredder, it is adviced to place
no more then 70% of the maximum amount of sheets to be shred at one time indicated
for each model by the producer. The maximum amount of sheet should be used only oc-
casionally.
It is forbidden to shred more sheets then the maximum amount of sheets to be shred at
one time indicated by the producer. It may cause the blockade of the machine and massive
engine overloading, which will diminish shredder's durability or even damage it . Also you
should not shred soft objects such as foil, paper towels, toilet paper or fabrics. Nor paper
© ArGO s.A.
EN
12
www.argo.pl