Argo SKY 350 Manuel d'instruction - Page 12

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Argo SKY 350. Argo SKY 350 12 pages.

Imprimer la page
troUble sHootinG GUide
Problem
machine has no power
Roller is not rolling
Excessive noise
No increase of temp.
Poor Laminating
Corner is not sealed
Emergency state

tecHnical data

model:
max Laminating Width
max Laminating Speed
Dimension
Weight
Power Source
Power Consumption
input Current
motor R.P.m
Number of Roller
note on environmental protection:
After the implementation of the European Directive 2002/96/EU in the national legal system,
the following applies: Electrical and electronic devices may not be disposed of with domestic
waste. Consumers are obliged by law to return electrical and electronic devices at the end of
their service lives to the public collecting points set up for this purpose or point of sale. Details
to this are defined by the national law of the respective country. this symbol on the product, the
instruction manual or the package indicates that a product is subject to these regulations. By re-
cycling, reusing the materials or other forms of utilising old devices, you are making an important
contribution to protecting our environment.
RoHS
© ARGO S.A.
Cause
Power cord not property plugged
Blown fuse on PCB
Power cord not property plugged
Power S/W off
Power motor is not driving
Operating gear part is not smooth
Power cord not property plugged
Blown fuse on PCB
Other
Laminated document wrinkled
Laminated document is cloudy or
has a curl
Document is too thickthat the edge
film is not sealed
Laminated document do not exit
properly
Something may be stuck between
the hot rollers
Hot rollers are out of position
1500 mm/min
544x240x117 mm
230V~ 50Hz
800W, + - 10%
Nasza oferta w internecie: www.argo.pl
Plug the cord properly
Check/Replace fuse
Plug the cord properly
Check/turn on the S/W
Contact A/S
Contact A/S
Plug the cord properly
Check/Replace fuse
Contact A/S
Adjust temp. Lower and/or
Speed Higher
Adjust temp. Higher and/or
Speed Lower
Use a thinner document or
leave more clearance with the
edge about 5mm
Push the main S/W
Clean the hot rollers
Set the hot rollers into proper
SKY 350
350 mm
13 kg
5 A
35 R.P.m.
6 EA
Solution