Sony MHC-EX5 Manuel d'utilisation - Page 25

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Sony MHC-EX5. Sony MHC-EX5 29 pages.

Imprimer la page
me) am Kolele
Precautions
Troubleshooting Guide
Maintenance
Specifications
Glossary
Index to Parts and Controls
Index
On safety
On installation
Place the stereo system in a location with
adequate ventilation to prevent heat
build-up in the stereo system.
On condensation in the CD player
component
If the system is brought directly from a cold
to a warm location, or is placed in a very
damp room, moisture may condense on the
lens inside the CD player. Should this
occur, the CD player will not operate.
Remove the CD and leave the system
turned on for about an hour until the
moisture evaporates.
To save a tape permanently
To prevent a tape from being accidentally
recorded over, break off the cassette tab
from side A or B as illustrated. If you later
want to reuse the tape for recording, cover
~ the broker tab with adhesive tape.
When you are using a TYPE ff (CrO,) or
TYPE IV (METAL) cassette, be careful not
to cover the detector slots which allow the
tape player to automatically detect the type
of tape.
V
Detector siots
Troubleshooting
Guide
If you run into any problem using this
stereo system, use the following check list.
And first check the following points:
The power cord is connected firmly.
« The speakers are connected correctly and
firmly.
Should any problem persist after you have
made the checks below, consult your
nearest Sony dealer.
Tuner
"TUNED" flashes in the display.
=> Adjust the aerial.
"STEREO" flashes in the display.
=> Adjust the aerial.
Severe hum or noise.
=> Adjust the aerial.
-> The signal strength is too weak.
Connect the external aerial.
=> Connect the ground wire.
A stereo FM programme cannot be
received in stereo.
=> Press STEREO/MONO so that
"STEREO" appears.
"No PTY Data" or "No Text Data"
appears in the display when trying
to receive RDS (Radio Data System)
information.
=> Contact the radio station and find
out whether or not they actually .
provide the RDS service in
question. If so, the service may be
temporarily out of order.
Tape Player
The tape does not record.
=> No tape in the cassette holder.
> The tab has been removed from the
cassette.
=> The tape has reeled to the end.
The indicator of the CD SYNCHRO
button flashes 3 times and
disappears.
=> The tab has been removed from the
cassette.
The indicator of the DUBBING MODE
(HIGH or NORMAL) button flashes
3 times and disappears.
= The tab has been removed from the
cassette.
The tape does not record nor
playback or there is a decrease in
sound level.
=> The heads are dirty. Clean them.
> Magnetic deposits have built-up on
the record / playback heads.*
There is excessive wow or flutter, or
the sound drops out.
=> The capstans or pinch rollers are
contaminated.*
The tape does not erase completely.
=> Magnetic deposits have built-up on
the record / playback heads.*
Noise increases or the high
frequencies are erased.
-> Magnetic deposits have built-up on
the record / playback heads."
*
See "Maintenance."
continue to next page >
For Your Information
2 5