Sony MHC-EX900 Manuel d'utilisation - Page 26
Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Sony MHC-EX900. Sony MHC-EX900 32 pages. Mini hi-fi component system
• The number of files has exceeded
5,000.
• Files that are encrypted or protected by
passwords, etc. cannot be played back.
* This system supports FAT16 and FAT32, but
some USB storage devices may not support
all of these FAT. For details, refer to the
operation manual of each USB storage
device or contact the manufacturer.
Tuner
Severe hum or noise, or stations
cannot be received. ("TUNED" or
"ST" flashes on the display.)
• Connect the antenna properly.
• Change antenna location and its
orientation to obtain good reception.
• Keep the antennas away from the
speaker cords, the power cord and the
USB cable to avoid picking up noise.
• Consult your nearest Sony dealer if the
supplied AM antenna has come off the
plastic stand.
• Turn off nearby electrical equipment.
To change the AM tuning interval
(Except for European, Russian and Saudi
Arabian models)
The AM tuning interval is preset to 9 kHz
or 10 kHz by factory default.
1
Tune to any AM station, and then
turn off the system.
2
Press DISPLAY to display the
clock.
3
While holding down TUNING + on
the unit, press ?/1 on the unit.
All the AM preset stations are erased.
To reset the interval to the factory
preset, repeat the procedure.
26
GB
To improve disc loading
performance
Turn on the CD player/USB device power
using the CD/USB power management
function. By default, the CD player/USB
device power is turned off.
1
Press FUNCTION repeatedly to
select the CD function.
2
Press ?/1 to turn off the system.
3
After "STANDBY" stops flashing,
press DISPLAY to display the clock
and then press ?/1 on the unit while
holding down x on the unit.
"CD/USB PWR ON" appears. Turning
the CD player/USB device power on,
decreases disc access time and
improves loading performance.
If there is poor tuner reception when
the CD player/USB device power is
turned on, return the setting to default.
To turn off the CD player/USB device
power, repeat the procedure until "CD/
USB PWR OFF" appears. Note that
when turning off the CD player/USB
device power in the tuner function,
power is not supplied to the USB
device, and the device is therefore not
recognized and not charged by the
system, even if connected.
To reset the system to factory
settings
If the system still does not operate
properly, reset the system to factory
settings. You cannot reset the system to
factory settings in Power Saving Mode.
Use buttons on the unit to reset the unit to
its factory default settings.
1
Disconnect and reconnect the
power cord, and then turn on the
system.