Sony SS-SHAKE33 Manuel d'utilisation - Page 42

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Sony SS-SHAKE33. Sony SS-SHAKE33 48 pages. Home audio system
Également pour Sony SS-SHAKE33 : Manuel d'entretien (10 pages)

Sony SS-SHAKE33 Manuel d'utilisation
NO STEP
All of the programmed steps have been
erased.
NO TRACK
No playable file is loaded in the system.
NOT IN USE
You tried to perform a specific operation
under conditions where that operation is
prohibited.
NOT SUPPORTED
An unsupported USB device is connected,
or the USB device is connected through a
USB hub.
OFF TIME NG
The on time and off time of Play Timer or
Recording Timer is the same.
PARTY GUEST
The system becomes a Party Guest when
Party Chain function is activated.
PARTY HOST
The system becomes a Party Host when
Party Chain function is activated.
PROTECTED
The USB device is write-protected.
PUSH STOP
You tried to perform an operation that can
be performed only when the playback is
stopped.
READING
The system is reading information of the
disc or USB device. Some operations are
not available.
REC ERROR
The transfer did not start, stopped
partway, or otherwise could not be
performed.
STEP FULL
You tried to program more than 25 steps.
TRACK FULL
You cannot transfer onto the USB device
because the number of file has reached its
maximum.
GB
42

Precautions

When carrying the unit
Perform the following procedure to
protect the disc mechanism.
Use the buttons on the unit to perform this
operation.
1
Press "/1 to turn on the system.
2
Press CD.
3
Remove the disc.
Press Z OPEN/CLOSE to open and
close the disc tray.
Wait until "NO DISC" appears in the
display panel.
4
Unplug the power cord.
Notes on discs
• Before playing, wipe the disc with a cleaning
cloth from the center outward to the edge.
• Do not clean discs with solvents, such as
benzine, thinner, or commercially available
cleaners or anti-static spray intended for vinyl
LPs.
• Do not expose discs to direct sunlight or heat
sources such as hot air ducts, nor leave it in a
car parked in direct sunlight.
On safety
• Completely disconnect the power cord (mains
lead) from the wall outlet (mains) if it is not
going to be used for an extended period of
time. When unplugging the unit, always grip
the plug. Never pull the cord itself.
• Should any solid object or liquid get into the
system, unplug the system, and have it
checked by qualified personnel before
operating it again.
• (USA and Canadian models only)
One blade of the plug is wider than other for
the purpose of safety and will fit to the wall
outlet only one way. If you are unable to insert
the plug fully into the outlet, contact your
dealer.
• AC power cord must be changed only at the
qualified service shop.