Sony STR-DA80ES - Fm Stereo / Fm-am Receiver Manuel d'utilisation - Page 21
Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Sony STR-DA80ES - Fm Stereo / Fm-am Receiver. Sony STR-DA80ES - Fm Stereo / Fm-am Receiver 40 pages. Limited warranty (es products)
Également pour Sony STR-DA80ES - Fm Stereo / Fm-am Receiver : Manuel d'utilisation (39 pages), Contexte technique (38 pages), Garantie limitée (1 pages)
Imprimer la page
z
If you feel the surround effect is inadequate
Do the procedure below to adjust the delay time for the
center and rear speakers.
1 Press SET UP repeatedly to select OTHER SETUP.
2 Use the digital processing control buttons ( V / v ) to
select CENTER DELAY or REAR DELAY and use the
buttons ( B / b ) to select the delay time.
Adjusting the speaker volume Z
Use the remote while seated in your listening position
to adjust the volume of each speaker.
Note
This receiver incorporates a new test tone with a frequency
centered at 800 Hz for easier speaker volume adjustment.
+
–
SUB CH
POSITION
0
)
— RMS —
DIRECTION
9
(
— SOUND FIELD —
ON/OFF
GENRE
SOUND FIELD
EQ/
TONE
BAND
ON/OFF
DIGTAL
DIRECT
PROCESSING
CONTROL
DPC MODE
DPC
MODE
PROGRAMMABLE
DIGITAL
PROCESSING
CONTROL
1
Press SOUND FIELD ON/OFF to turn on the
sound field.
2
Press GENRE repeatedly to select "DOLBY."
3
Press MODE to select "NORMAL SURROUND"
or "ENHANCED SURROUND."
4
Press DPC MODE repeatedly until the SUR
indicator lights up.
5
Press TEST TONE.
You will hear the test tone from each speaker in
sequence.
ANT
SWAP
TV/VTR
=
+
D. SKIP
GENRE
CLEAR
P IN P
JUMP
p
P
r
TEST
MODE
TONE
TEST TONE
SLOPE
— LEVEL —
+
+
MODE
REAR
CENTER
–
–
MASTER
BASS
VOL
BOOST
MUTING
Dolby Surround Setup
6
From your listening position, use the digital
processing control buttons (
parameter to be set and use the buttons (
to select the setting so that the test tone can be
heard at the same level from all speakers.
To adjust
Select
rear speaker
REAR L R
balance
rear speaker
REAR
level
center speaker
CENTER
level
subwoofer
SUB WOOFER
level
During adjustment of the respective speaker level/
balance, the test tone is output from the speaker(s)
only.
After adjusting the subwoofer level, the test tone
turns off automatically.
To turn off the test tone
Press TEST TONE.
Notes
• Be sure to select "NORMAL SURROUND" or
"ENHANCED SURROUND" before outputting the test
tone.
• The test tone is not output when:
— The DIRECT PASS button is on.
— "MUTING" appears in the display.
Getting Started
/
) to select the
/
)
And set between
L (left) and R (right)
–20.0dB and +10.0dB
(in 0.5 dB steps)
–20.0dB and +10.0dB
(in 0.5 dB steps)
–20.0dB and +10.0dB
(in 0.5 dB steps)
21