Cisco ASA 5585-X Manuel d'entretien - Page 23

Parcourez en ligne ou téléchargez le pdf Manuel d'entretien pour {nom_de_la_catégorie} Cisco ASA 5585-X. Cisco ASA 5585-X 44 pages. Maintenance and upgrade procedures
Également pour Cisco ASA 5585-X : Manuel de démarrage rapide (40 pages), Manuel de démarrage rapide (6 pages)

Imprimer la page

Chapter 4

Maintenance and Upgrade Procedures

Figure 4-19

Terminal block cover

Step 10

Repeat Steps 2 through 9 to connect power to the second power-supply module.

Note

Remove any safety flag and lockout devices, or any tape, from the source DC circuit breaker

Step 11

switch handle.

Step 12

Verify that the power cable ends at the power source are connected.

Restart power by moving the circuit breaker switch handle to the on (!) position.

Step 13

If you powered off the appliance because you are removing and replacing both power supply modules,

Step 14

power it back on. If you replaced only one power supply module, the power source is already on. You

can hot swap the module you are replacing and then turn its power back on.

OL-22567-02

Reinstalling the Terminal Block Cover

You must have two DC power-supply modules installed at all times.

Cisco ASA 5585-X Adaptive Security Appliance Hardware Installation Guide

Removing and Installing the Power Supply Module

Terminal block

4-23