Cisco ASR 9000 Series Configuration des paramètres du réseau - Page 23

Parcourez en ligne ou téléchargez le pdf Configuration des paramètres du réseau pour {nom_de_la_catégorie} Cisco ASR 9000 Series. Cisco ASR 9000 Series 26 pages. Line card
Également pour Cisco ASR 9000 Series : Manuel de configuration (46 pages), Manuel de configuration (50 pages), Manuel (24 pages), Configuration (46 pages), Manuel (44 pages), Manuel de référence rapide (7 pages)

Configuring the Satellite Network Virtualization (nV) System on the Cisco ASR 9000 Series Router

Satellite Interface Configuration

The Satellite interface can be used as any other regular GigabitEthernet interfaces:

interface GigabitEthernet200/0/0/0

l2transport

interface GigabitEthernet200/0/0/0

ip address 99.0.0.1 255.255.255.0

interface GigabitEthernet200/0/0/2

bundle id 100 mode active

Satellite Management using private VRF

You can use a special private VRF instead of the global default routing table, to configure the loopback

interface and ICLs used for satellite management traffic. IP addresses in this VRF will not conflict with

any other addresses used on the router.

router(config)# vrf NV_MGMT_VRF

router(config)# address ipv4 unicast

router(config)# interface Loopback 1000

router(config)# vrf NV_MGMT_VRF

router(config)# ipv4 address 10.0.0.1 / 24

router(config)# interface TenGige 0/1/0/3

router(config)# vrf NV_MGMT_VRF

router(config)# ipv4 point-to-point

router(config)# ipv4 unnumbered Loopback 1000

router(config)# nv

router(config-nv)# satellite-fabric-link satellite 500

router(config-nv)# remote-ports GigabitEthernet 0/0/28-39

router(config)# nv satellite 500

router(config)# ipv4 address 10.0.0.2 / 24

Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Configuration Guide

OL-26061-03

Configuration Examples for Satellite nV System

HC-729