Cisco ATM Cable Interface Processor ACIP-SM(=) Manuel d'installation et de configuration - Page 25
Parcourez en ligne ou téléchargez le pdf Manuel d'installation et de configuration pour {nom_de_la_catégorie} Cisco ATM Cable Interface Processor ACIP-SM(=). Cisco ATM Cable Interface Processor ACIP-SM(=) 33 pages. Atm cable interface processor (acip)
Imprimer la page
Monitor and Maintain the ACIP
After configuring the new interface, you can display its status. You can also display the current status
of connections and active modems on each interface. To show current status information, perform
the following tasks in EXEC mode:
Task
Display the configured cable channels status.
Display the active modems.
Display the ATM interface status.
Display the BVI interface status.
Configuration Example
This section contains an example that shows how to configure the ACIP interface; it also shows other
Cisco IOS commands required for the ACIP to connect to a cable headend (modem).
Each ATM virtual circuit carries data for a single subscriber cable data modem. Data sent over this
interface is first encapsulated in Ethernet frames and then encapsulated in AAL5 CPCS-PDU (per
RFC 1483 LLC SNAP Encapsulation of Bridged Protocols). To support encapsulation, the router
must operate as an integrated router/bridge by using the bridge irb command and the bridge-group
virtual interface (interface bvi command). The bridge-group virtual interface decapsulates the
Ethernet packets received from the ATM interface and multiplexes the router interface to multiple
VCs. No actual bridging is performed between VCs.
All of the IP devices on each of the Ethernet interfaces of the subscriber cable data modem must be
on the same IP subnet. The router, in general, will not perform an ARP to find MAC addresses of
hosts; instead, the router will assume that DHCP is used by each host. Because entries in the ARP
table must not age out normally, the software automatically adds the bridge number aging-time
604800 command to the configuration file.
Data from one host to another on the same cable channel must be sent via the router. The router
knows that two hosts are both on the same subnet and would normally send an ICMP redirect to
inform the first host that a better path exists. However, because the cable media does not support
direct host-to-host communications, the router must do the forwarding, and the ICMP must be
suppressed with the no ip redirects command.
The cable bind command specifies the headend IP address (1.1.1.2), and the BVI interface specifies
the local IP address (1.1.1.1).
Router(config)# interface atm 5/0
Router(config-if)# bridge-group 1
Router(config-if)# bridge-group 1 spanning-disable
Router(config-if)# no shutdown
Router(config-if)# exit
Router(config)# cable bind atm 5/0 17 1.1.1.2
Router(config)# bridge irb
Router(config)# interface bvi 1
Router(config-if)# ip address 1.1.1.1 255.255.255.0
Router(config-if)# no ip redirects
Router(config-if)# exit
Router(config)# bridge 1 protocol dec
Router(config)# bridge 1 route ip
Router(config)# exit
Command
show cable channel
show cable modem
show interface atm slot/number
show interface bvi slot/number
ATM Cable Interface Processor (ACIP) Installation and Configuration
Configuring the ACIP
25