Cisco C7200-I - Input/Output Controller - Control Processor Manuel de l'utilisateur - Page 7
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Cisco C7200-I - Input/Output Controller - Control Processor. Cisco C7200-I - Input/Output Controller - Control Processor 16 pages. Input/output controllers
Imprimer la page
Cisco 7200-I/O-GE+E and Cisco 7200-I/O-2FE/E Input/Output Controllers
Configuring the Gigabit Ethernet Interface on the Cisco 7200-I/O-GE+E
The following example configures the Gigabit Ethernet interface on the Cisco 7200-I/O-GE+E. The
following commands are configured on slot 0, port 0.
Router# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)# interface gigabitethernet 0/0
Router(config-if)# ip address 1.1.1.10 255.255.255.252
Router(config-if)# negotiation auto
Router(config-if)# end
Configuring Autonegotiation on the Cisco 7200-I/O-2FE/E
The following example configures the Fast Ethernet interface on the Cisco 7200-I/O-2FE/E for fully
enabled autonegotiation:
Router# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)# interface fastethernet 0/0
Router(config-if)# duplex auto
Router(config-if)# speed auto
Command Reference
This section documents new or modified commands. All other commands used with this feature are
documented in the Cisco IOS Release 12.1 command reference publications.
•
•
•
•
interface gigabitethernet
negotiation
show controllers gigabitethernet
show interfaces gigabitethernet
Command Reference
12.1(5)T and 12.2(14) S
7