Argo Vanguard 2 Manuel d'entretien - Page 16
Parcourez en ligne ou téléchargez le pdf Manuel d'entretien pour {nom_de_la_catégorie} Argo Vanguard 2. Argo Vanguard 2 16 pages. Ducting & exhaust
Argo Service Manual
3.
Fasten the duct at the upper hood brace assembly
4.
Perform the servicing procedure, Installing the Muffler (Response, Vanguard2
and Vanguard Models) or: Installing the Muffler (Bigfoot Models)
5.
Reinstall the bumper.
Removing the Exhaust Ducting (Conquest from C19686, all 6x6 Conquests and all
35th anniversary vehicles)
1.
Perform the servicing procedure, Removing the Muffler (Conquest) on page DE-7
of this service guide.
2.
Remove the 2 fasteners securing the exhaust ducting to the hood support brace. See
Photo DE-32 previous page.
3.
The exhaust ducting is secured at the other end by a body rivet located at the upper
body beneath the rubber bumper. See Photo DE-33 previous page Peel back the
bumper and drill out both rivets.
4.
Pull the duct assembly in towards the engine compartment and up and out of the
vehicle.
Installing the Exhaust Ducting (Conquest from C19686, all 6x6 Conquests and all
35th anniversary vehicles)
1.
Insert the ducting into the engine compartment. Slip the exhaust duct support be-
tween the upper and lower body aligning the holes in the support, with the rivet
holes of the previously removed rivets.
2.
Insert 2 body rivets through the body and shroud support, and secure with 2 washers
below.
3.
Fasten the duct at the upper hood brace assembly
4.
Perform the servicing procedure, Installing the Muffler (Conquest) on page DE-8
of this service guide.
5.
Reinstall the bumper.
Ontario Drive & Gear Limited
PH.(519)- 662-2840 FAX (519)- 662-2421
Ducting & Exhaust
DE-15
www.odg.com