Argo Vanguard Series Manuel d'entretien - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel d'entretien pour {nom_de_la_catégorie} Argo Vanguard Series. Argo Vanguard Series 12 pages. Fuel system
Également pour Argo Vanguard Series : Manuel d'entretien (16 pages)

Imprimer la page

Argo Service Manual

IMPOR

IMPORT T T T T ANT

IMPOR

Depending on the design of the fuel tank,

earlier models may require that the tank

be removed from the vehicle by pulling it

from the seat frame into the rear

compartment. The tank will need to be

raised high enough for the sediment bowl

to clear the seat frame assembly below.

To provide enough clearance, shim the

seat support at the 4 corners where the

storage tray fasteners were removed. Photo FS-3

Undo the gear clamp securing the filler hose at the fuel tank neck and pull the filler

neck assembly free of the tank. Pull the assembly from the tank at the fuel cap.

Photo FS-4

The filler necks of vehicles manufactured prior to CB14963, RB14945, BF10092,

SN10111 & S10112, may not be pulled through the upper body filler hole as shown

below. Filler necks in these earlier models have a small metal vent tube welded to

the filler neck, to which the vent tube is crimped. Pull the tank from the vehicle

along with the filler neck assembly until the vent line is visible and can be

disconnected from the filler neck tube

Pull the fuel tank up through the seat frame assembly and free of the vehicle.

Photo FS-5

Ensure that the vent tube does not pull out from the filler neck and that it is not

kinked in any way when the filler neck assembly is reassembled to the new tank.

Unthread the fuel pickup tube from the tank and discard.

Ontario Drive & Gear Limited

PH.(519)- 662-2840 FAX (519)- 662-2421

ANT

IMPOR

IMPORT T T T T ANT

IMPOR

FS-4

FS-5

ANT

Fuel System

FS-3

FS-5