Cisco Catalyst 2960-X Manuel d'installation du matériel - Page 2
Parcourez en ligne ou téléchargez le pdf Manuel d'installation du matériel pour {nom_de_la_catégorie} Cisco Catalyst 2960-X. Cisco Catalyst 2960-X 34 pages.
Également pour Cisco Catalyst 2960-X : Manuel de démarrage (25 pages), Manuel du matériel (20 pages)
Imprimer la page
Safety Warnings
Before working on equipment that is connected to power lines, remove jewelry (including rings, necklaces,
Warning
and watches). Metal objects will heat up when connected to power and ground and can cause serious burns
or weld the metal object to the terminals. Statement 43
Warning
Do not stack the chassis on any other equipment. If the chassis falls, it can cause severe bodily injury and
equipment damage. Statement 48
Warning
This product must be connected to a power-over-ethernet (PoE) IEEE 802.3af compliant power source or
an IEC60950 compliant limited power source. Statement 353
Warning
Read the wall-mounting instructions carefully before beginning installation. Failure to use the correct
hardware or to follow the correct procedures could result in a hazardous situation to people and damage
to the system. Statement 378
If a Cisco external power system is not connected to the switch, install the provided connector cover on
Warning
the back of the switch. Statement 386
Warning
Attach only the following Cisco external power system to the switch: PWR-RPS2300 Statement 387
Do not work on the system or connect or disconnect cables during periods of lightning activity. Statement
Warning
1001
Read the installation instructions before connecting the system to the power source. Statement 1004
Warning
To prevent bodily injury when mounting or servicing this unit in a rack, you must take special precautions
Warning
to ensure that the system remains stable. The following guidelines are provided to ensure your safety:
• This unit should be mounted at the bottom of the rack if it is the only unit in the rack.
• When mounting this unit in a partially filled rack, load the rack from the bottom to the top with the
heaviest component at the bottom of the rack.
• If the rack is provided with stabilizing devices, install the stabilizers before mounting or servicing
the unit in the rack.
Statement 1006
Catalyst 2960-X and 2960-XR Switch Hardware Installation Guide
2
Switch Installation
OL-28309-02