Cisco Catalyst 8300 Series Manuel d'installation du matériel - Page 28
Parcourez en ligne ou téléchargez le pdf Manuel d'installation du matériel pour {nom_de_la_catégorie} Cisco Catalyst 8300 Series. Cisco Catalyst 8300 Series 46 pages. Edge ucpe
Imprimer la pageInstalling the Cisco Catalyst 8300 Series Edge uCPE
1. Attach the brackets to the device using the screws provided with the mounting kit.
Two screws should be used to attach each bracket to the chassis as shown in the following figure.
Note
The wall-mounting kit is different from the rack-mounting kit.
Figure 10. Showing securing of brackets to the side of the device for wall-mounting
1
2
3
2. Fix the chassis to the wall using the brackets that you attached to the device.
The screws or anchors for attaching the device to the wall are not provided with the kit. Depending on
the type of wall (wood, brick, stone etc), use appropriate screws or anchors to fix the device to the wall.
Note
Route the cables so that they do not put a strain on the connectors or mounting hardware. For safety reasons,
the chassis may only be mounted with ports going out in left or right direction. Do not mount the chassis with
ports facing upward or downward direction.
Cisco Catalyst 8300 Series Edge uCPE Hardware Installation Guide
24
Install the Cisco Catalyst 8300 Series Edge uCPE
Mounting bracket
Securing screws
Bushings