Digitone Call Blocker 10 Manuel du propriétaire - Page 2

Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Digitone Call Blocker 10. Digitone Call Blocker 10 13 pages. Automatically blocks and routes screened calls with caller id

Imprimer la page

Digitone Call Blocker

Setup

™

Thank you for choosing Digitone's Call Blocker™ Model 10 as your Personal Communicator.

Digitone

Communications is confident that you will find Digitone's unique preset features and flexibility are just the

answer for your communications needs. Just connect your telephone and you're ready to go. You don't

need to set any codes as Digitone's Call Blocker can operate right out of the box.

No Battery Backup is Needed -

If there is a power outage, all of the program settings remain intact.

1. Connect the supplied line cord to your telephone wall jack and then to the Line Port on the Call

Blocker. You must connect the Line cord and your phone to the correct ports in order for the Digitone

Call Blocker to operate properly. Initially, "Line In Wrong Port" will show on the display until the Line

cord is plugged into the LINE port. "Check Cords" will display if the Line cord is disconnected afterwards.

2. Plug the small end of the Power Supply into the port labeled "24VDC" on the Call Blocker, next plug in

the Power Supply to a 120VAC wall receptacle.

3. Connect your combo Phone/Answer Machine system to the TEL phone port of the Call Blocker and set

to 3-5 rings. Note if you are using Voice Mail services from your phone company, then don't enable any

answering devices there in your home or office.

4. Optional: Connect an answer machine to any phone wall plate and set the answer delay to 4-6 rings,

or 1-2 rings greater than the answering device in the TEL phone port. This separate answer machine will

capture any uninvited calls not answered by the Combo Phone/Answering device in the TEL phone port.