Cisco CSC-C2FCIT Installation et mise à niveau - Page 17

Parcourez en ligne ou téléchargez le pdf Installation et mise à niveau pour {nom_de_la_catégorie} Cisco CSC-C2FCIT. Cisco CSC-C2FCIT 32 pages. Fddi card and appliques

Imprimer la page

Figure 10

FDDI Applique and Applique Card Cage—Exploded View

Cover fasteners

Guide pins

Filler plate

Tab

Card guide

Slot

If the card cage is empty, remove both ﬁller plates from the rear. (See Figure 10.) If an

Step 4

applique is currently installed, remove only the ﬁller plate.

Step 5

If you are installing only one applique in an empty card cage, install the FDDI applique,

with its attached faceplate, into the right side of the card cage. (Orient the card cage as in

Figure 10 for the following steps.)

Position the applique so the status LEDs are on the bottom. Ensure that the tab on the

Step 6

bottom of the applique faceplate is inserted into the slot in the bottom of the applique card

cage and that the applique is seated in the card guide. (See Figure 10.)

Step 7

For one applique only—If you are installing only one FDDI applique, insert the blank

faceplate in the left side of the card cage, sliding it down so that the front edge aligns with

the faceplate on the right side of the card cage.

For two appliques only—If you are installing a second FDDI applique in the card cage,

install the applique in the left side of the card cage by sliding it down so that the faceplate

aligns with the faceplate of the applique on the right side of the card cage. Insert the

applique into the card cage with the status LEDs on the bottom. Ensure that the tab on the

bottom of the applique faceplate is inserted into the slot in the bottom of the applique card

cage and that the applique is seated in the card guide. (See Figure 10.)

Step 8

Replace the top cover of the applique card cage. Ensure correct alignment of the cover with

the two guide pins on the bottom of the cover. The guide pins should pass through the

alignment holes in the tabs on the top of each applique and faceplate assembly. Secure the

top cover to the card cage with the four cover fasteners. (See Figure 10.)

Cover

Applique

Faceplate

Installing and Upgrading the CSC-C2FCIT FDDI Card and Appliques

Installing Cards and Appliques