Cisco Firepower 4110 Pour commencer - Page 17

Parcourez en ligne ou téléchargez le pdf Pour commencer pour {nom_de_la_catégorie} Cisco Firepower 4110. Cisco Firepower 4110 42 pages. Rack-mount and ground the chassis
Également pour Cisco Firepower 4110 : Manuel de maintenance et de mise à jour (20 pages), Manuel (36 pages), Manuel (26 pages), Manuel (8 pages), Manuel (42 pages)

Imprimer la page
Cisco Firepower 4110 Pour commencer
Getting Started
Cabling for the Firepower 4100
Perform the initial Firepower Threat Defense configuration on the logical device Management interface. You
can later enable management from any data interface. The Firepower Threat Defense device requires internet
access for licensing and updates, and the default behavior is to route management traffic to the gateway IP
address you specified when you deployed the device. If you want to route management traffic over the
backplane to the data interfaces instead, you can configure that setting in the FDM later.
Cable the following interfaces for initial chassis setup, continued monitoring, and logical device use.
• Console port—Connect your management computer to the console port to perform initial setup of the
• Chassis Management port—Connect the chassis management port to your management network for
• FTD Logical device Management interface—You can choose any interface on the chassis for this purpose
• Data interfaces—Connect the data interfaces to your logical device data networks. You can configure
Note
chassis. The Firepower 4100 includes an RS-232–to–RJ-45 serial console cable. You might need to use
a third party serial-to-USB cable to make the connection.
configuration and ongoing chassis management.
other than the chassis management port, which is reserved for FXOS management.
physical interfaces, EtherChannels, and breakout ports to divide up high-capacity interfaces.
For High Availability, use a Data interface for the failover/state link.
All interfaces other than the console port require SFP/SFP+/QSFP transceivers. See the
guide
for supported transceivers.
Cabling for the Firepower 4100
hardware installation
Getting Started
17