Cisco IAD2430 Series Manuel de démarrage rapide - Page 33
Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} Cisco IAD2430 Series. Cisco IAD2430 Series 34 pages. Integrated access device
Également pour Cisco IAD2430 Series : Manuel de synthèse (13 pages), Vue d'ensemble (16 pages)
Imprimer la page
Command
Step 7
Repeat Step 3 through Step 6 for each additional DS0
group.
Step 8
Router(config-ctrl)# no shutdown
Step 9
Router(config-ctrl)# exit
Step 10
Router(config)# exit
Step 11
Router# show controller t1/e1 1/0
For additional information about configuring specific features, see the following references:
• For PPP, HDLC, or FR, consult the online master index for the Cisco IOS release that you are using.
• For loopback diagnostics, or for configuring controller channel groups, channel-associated signaling (CAS) voice groups,
or time-division multiplexing (TDM) cross-connects, see the Cisco IAD2430 Series Integrated Access Devices Software
Configuration Guide.
Verifying and Saving Your Configuration
To verify the configuration and save it in NVRAM so that the configuration remains in effect if the Cisco IAD is restarted, enter
the following commands:
Command
Router# show running-config
Router# show startup-config
Router# show controller t1/e1 1/0
Router# copy running-config startup-config
Description
Configures additional DS0 groups on the T1/E1 interface. You
can configure as many as 24 DS0 groups on a T1/E1 interface.
Configure a maximum of 8 time slots in a DS0 group
Note
on the Cisco IAD2435 IAD.
Activates the T1/E1 controller.
Exits controller configuration mode.
Exits configuration mode.
Verifies the controller configuration.
Description
Displays the current operating configuration, including any changes you
have made.
Displays the configuration currently stored in NVRAM.
Displays the configuration of the T1/E1 network interface controller.
Writes the current running configuration to NVRAM, where it overwrites the
startup configuration and becomes the new startup configuration.
If you reboot the Cisco IAD2430 series IAD or turn off the power
Note
before you complete this step, you lose the configuration.
33