argon audio Octave 5A Manuel du propriétaire - Page 13
Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} argon audio Octave 5A. argon audio Octave 5A 14 pages.
Imprimer la page
For "Auto Power Up" (APU) there are 3 different settings
you can choose from:
No APU
•
means you need to turn Argon Octave 5A On
manually (see above)
APU1 – scanning all inputs
•
Argon Octave 5A will make a cycling process and
scan all five inputs for signal. The process takes
about 3 seconds
•
While searching for an active input the Blue light
will flash in the display-eye.
•
When a signal is found, Argon Octave 5A will
automatically turn On.
If you have several sources connected to the
Argon Octave 5A it's recommended to use this
setting.
APU2 – detect only last selected source
•
Which also means that only the last played input
source can turn on the Argon Octave 5A. If you
have only one input connected its recommended
to use this setting.
Setting/changing the APU mode
Setting - No APU
•
Unplug the AC power cable from the back side of
Argon Octave 5A.
•
Press and hold the volume/input knob while you
insert the AC power cable again.
•
When the display-eye on the front start to flash
yellow, release the knob.
w w w . a r g o n a u d i o . c o m
O c t a v e 5 A
•
APU is now set to have no APU and Argon
Octave 5A will go into standby
Setting - APU1
•
Unplug the AC power cable from the back side of
Argon Octave 5A.
•
Press and hold the volume/input knob while you
insert the AC power cable again.
•
When the display-eye on the front start to flash
yellow, release the knob.
•
Press and release the knob again ONCE while
the yellow light is still flashing (press within five
seconds)
•
APU is now set to cycling process and Argon
Octave 5A will go into standby
Setting – APU2
•
Unplug the AC power cable from the back side of
Argon Octave 5A.
•
Press and hold the volume/input knob while you
insert the AC power cable again.
•
When the display-eye on the front start to flash
yellow, release the knob.
•
Press and release the knob again TWICE while
the yellow light is still flashing (press within five
seconds)
•
APU is now set to APU on last selected source
and Argon Octave 5A will go into standby.
1 3