Digitrax LocoMotion DN163K0b Manuel - Page 2

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Digitrax LocoMotion DN163K0b. Digitrax LocoMotion DN163K0b 8 pages. N scale mobile decoder

Imprimer la page

P P a a r r t t s s L L i i s s t t

1 DN163K0b Decoder

I I n n s s t t a a l l l l a a t t i i o o n n I I n n f f o o r r m m a a t t i i o o n n

See the Digitrax Decoder Manual for complete decoder test procedures, instal-

lation instructions, programming and technical information. Digitrax manuals

and instructions are updated periodically. Please visit www.digitrax.com for the

latest versions, technical updates and additional locomotive-specific installation

instructions.

I I n n s s t t a a l l l l a a t t i i o o n n I I n n s s t t r r u u c c t t i i o o n n s s - - K K a a t t o o N N - - S S c c a a l l e e F F 3 3 A A L L o o c c o o m m o o t t i i v v e e

1. Carefully remove

the locomotive's

shell from the

frame.

2. Remove the black

plastic cab seat

panel by gently

pressing in at the

sides.

3. Carefully remove

the plastic plug

that retains the

brass motor clips

and bend the

brass motor clips

up and away from the circuit board.

4. Slide the circuit board forward to release it from the clip on the locomotive

frame and lift the board off the frame.

5. Remove the brass pickup rail from one side of the locomotive, being careful

not to bend it. Wrap a small piece of yellow Kapton tape (supplied with the

Digitrax decoder) around the rail just to the front of the dimple (between the

dotted lines in photo, right). The tape should wrap around the outside edge

to ensure the brass motor clip is completely isolated from the brass pickup

rail when it is reinstalled. Trim excess tape on the INSIDE edge of the brass

pickup rail and reinstall it in the locomotive, lining it up over the position

pin. Repeat the process for the other brass pick up rail. (Figure 2)

D D

C C

i i g g i i t t r r a a x x

o o m m m m a a n n d d

R R u u n n Y Y o o u u r r T T r r a a i i n n s s , , N N o o t t Y Y o o u u r r T T r r a a c c k k ! !

Figure 1: Remove loco shell, remove cab seat pane,

remove plastic plug, bend brass motor clips up, slide

board forward, remove board

www.digitrax.com

C C

o o n n t t r r o o l l

1 Instruction sheet

Brass motor clips

Plastic Plug

Cab seat

panel