Digitrax UT1 Manuel - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Digitrax UT1. Digitrax UT1 11 pages. Traditional style loconet throttle

Imprimer la page

2.2 Turning Off Track Power

Turn off the track power by pressing and holding the "RUN/STOP" but-

ton, then simultaneously pressing the "OFF/F2"button. The com-

mand station will beep once and the "TRACK STATUS" light on the

command station will go out.

2.3 Running a Locomotive

Connect UT1 to any LocoNet jack connected to the command station in

your LocoNet system.

2.3.1 Run An Analog Locomotive on Address "00"

The address "00" is reserved for "Analog" locomotives or any locomotive not

equipped with a decoder.

1. Place a non-decoder equipped locomotive on the track. The locomo-

tive will make a "humming noise", this is the normal sound an ana-

log locomotive will make on a DCC layout.

2. Select the two digit address "00" of the analog locomotive you want

to run using the rotary dial selectors on the UT1. The left rotary dial

selects the "tens" and the right rotary dial selects the "ones".

3. Press "ACQ/DISP" to select locomotive. The "STATUS" LED

should be a steady green to indicate that you now control that loco-

motive.

4. If the "STATUS" LED is off, the locomotive that you tried to select

is already being controlled by another throttle in the system and is

not available.

5. A red "STATUS" LED indicates that the direction switch is not set

to the same direction as the locomotive you are trying to select.

Reverse the direction toggle switch and the "STATUS" LED will

turn green.

6. Strobing green "Chase Lights" across the top of the keyboard indi-

cate the throttle speed is higher or lower than the locomotive you

are trying to select. If the LEDs are strobing Left to Right, turn the

throttle knob clockwise until the LEDs stop strobing and the "STA-

TUS" LED turns green. If the LEDs are strobing Right to Left, turn

the throttle knob counter clockwise until the LEDs stop strobing and

the "STATUS" LED turns green. NOTE: if the "STATUS" LED is

red then change the direction of the toggle switch.

7. Flipping the toggle switch to the left will make the locomotive go

forward. Flipping the toggle to the right will make the locomotive

go in reverse.

8. Turn the throttle knob clockwise to increase speed and counter

clockwise to decrease the speed. The throttle knob can rotate

approximately. 300 degrees from start to stop.

2.3.2 Run A DCC Equipped Locomotive

Connect UT1 to any LocoNet jack on your LocoNet System.

In order to select a DCC locomotive, you must know its address. All

Digitrax decoders are factory programmed to the default 2 digit

short address "03." If your decoder has not been re-programmed

then select "03" as the address.

1. Select the two digit address "03" of the DCC locomotive you want

to run using the rotary selectors on the UT1. The left rotary selects

the "tens" and the right rotary selects the "ones".

2. Press "ACQ/DISP" to select locomotive. The "STATUS" LED

should be a steady green to indicate that you now control that loco-

motive.

3. If the "STATUS" LED is dark, the locomotive that you tried to select