Digitrax BDL162 Manuel - Page 9

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Digitrax BDL162. Digitrax BDL162 13 pages. Loconet occupancy detector

Imprimer la page

When the BDL162 is connected to LocoNet, it will communicate coded detec-

tion information to the system. If you wish to report BDL162 status to LocoNet

and attached devices or computers that can interpret these messages, you will

probably want to set up a unique board address for each BDL162. Board

addresses can range from 01 to 999. It is recommended that you make a record

of the addresses you use for all devices connected to your layout.

8.1 To set up the BDL162 board address

1. Power up your BDL162.

2. Press the switch behind the green ID LED for about 1 second, then release

it. The green ID LED will blink. The red option LED will not light. This

let's you know that you are in board address set up mode.

3. Connect a DT or UT series Digitrax throttle to the BDL162's LocoNet con-

nector.

4. Go into SWITCH mode on the throttle. Select the switch number that corre-

sponds to the board address you want to set and issue a closed

to set the board address. The board address is changed as soon as you issue

the

command. See following instructions for using specific Digitrax

SWITCH

throttles for setting the address.

DT100, DT200 or DT300 series throttle, press the MODE/DISP key on the

throttle to enter

SWITCH

mode. Use the throttle to dial up the board address

you would like to assign to the BDL162. When the address is in the display,

press the

key to issue a closed command. This will set the board address for

the BDL162. The green LED will then go steady green to indicate BDL162

Power on.

UT series throttle, press the

RUN/STOP

time to enter

SWITCH

mode. With a UT throttle, dial up the board address you

would like to assign to the BDL162. Press the

LED is lit. This will set the board address for the BDL162. The green LED will

then go steady green to indicate BDL162 Power ON. When you are finished

setting up BDL162's board address, return to

and

keys at the same time to exit

RUN/STOP

DISP/OPSW

DT400 series throttle, press

SWCH

keyboard to enter the board address number you want to set. Press the

set the address. To return to

"LOCO"

twice.

Note that an auto-reverse section can only use detection sections that are

contained in a BDL162 zone that is correctly set up for auto-reversing. See

Figure 5: Reversing Section Wiring for a wiring example.

www.digitrax.com

command

"c"

and

keys at the same

DISP/OPSW

key until the corresponding

LOCO

mode by pressing the

mode.

SWITCH

key to enter into the switch mode. Use the

key to

mode press the

EXIT

key or the

LOCO

Figure 5: Reversing Section Wiring Example

key