Digitrax PS2012 Manuel - Page 4
Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Digitrax PS2012. Digitrax PS2012 4 pages. 20 amp all scales regulated power supply
Imprimer la page
Configuration
To connect the PS2012 to boosters and other 5 amp rated devices, use the 'Y'
cable shown below:
Black wire to black post
Red wire to red post
5 amp self-resetting
current limiters
Figure 3
Two 'Y' cables are required for 4 boosters at 5 amps. Additional 'Y' cables can
can ordered from your local dealer. The 'Y' cable part number is YC52
The final step is to properly set the front panel selector switch for your scale:
The 'G' setting configures the supply to output 23 volts at 12 amps max.
The 'HO' setting configures the supply to output 18 volts at 15 amps max.
The 'N' setting configures the supply to output 13.8 volts at 20 amps max.
Warranty & Repair
Digitrax gives a one year "No Worries" Warranty against manufacturing
defects and accidental customer damage on all Digitrax products. That's it! A
simple, straightforward warranty with no tricky language! For complete
warranty and repair details see www.digitrax.com. Please contact Digitrax
tech support at (850) 872 9890 before sending anything to us for service so
that we can try and resolve the problem by phone or e-mail. Except as
expressly stated in the full warranty statement, there are no warranties,
express or implied, including but not limited to any warranties of merchant-
ability or fitness for a particular purpose.
©
0 2
4 0
D
g i
r t i
x a
I ,
c n
To PS2012 output bind-
ing posts
Digitrax, Inc. is not responsible for unintentional
errors or omissions in this document.
w
w
D
C
igitrax
Run Your Trains, Not Your Track!
w
d .
g i
t i
a r
. x
o c
m
C
ommand
ontrol
Power outputs to
boosters or other
devices
Tape
unused
outputs
4