Argonaut G615XLR Manuel de référence - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel de référence pour {nom_de_la_catégorie} Argonaut G615XLR. Argonaut G615XLR 20 pages. Marine monitor

Wiring

NOTE: THE POSITIVE WIRE IS RED AND THE NEGATIVE IS BLACK.

The standard cables include VGA, DVI, RCA/S-Video, and DC Power cable. All cables exit the rear of the

monitor through a waterproof cable clamp. Note that the input cable ends are not waterproof and

should be placed or installed in a dry, protected area. DO NOT PULL CABLES TIGHT IN ORDER

TO PREVENT EXCESS STRAIN AND POSSIBLE BREAK IN CABLE CLAMP SEAL. Contact

your Argonaut Dealer if additional cable lengths are required in excess of standard provided.

Power

The G615XLR monitor is designed for 12 Volt power input through an Argonaut supplied power regulator.

The correct regulator is specified at time of ordering for connection to either a 12 volt or 24 volt system.

The regulators accept a range of voltage (either 9 to 18V or 19 to 32V) and provide a steady 12 volts to the

monitor.

NOTE: ANY DIRECT CONNECTION OF THE MONITOR TO 12 OR 24 VOLT

POWER WITHOUT FIRST RUNNING THROUGH THE ARGONAUT SUPPLIED REGULATOR

COULD PERMANENTLY DAMAGE THE MONITOR AND VOID YOUR WARRANTY. DO

NOT CONNECT THE REGULATOR TO VOLTAGE EXCEEDING THE SPECIFIED RANGE AS

THIS WILL DAMAGE THE REGULATOR. DO NOT CONNECT THE MONITOR DIRECTLY

TO A/C POWER (110-220V) POWER AS THIS WILL DAMAGE THE DISPLAY AND COULD

CAUSE A FIRE.

PLEASE MAKE SURE TO AVOID IMPROPER CROSSING WIRES

(POSITIVE TO NEGATIVE) AS THIS CAN DAMAGE THE DISPLAY ELECTRONICS

Care & Precautions

Care: The LCD has a special coating to prevent reflection. Clean with soft clean cloth or cotton and

alcohol. Commercially available "Kensington Screen Guardian" for antiglare screens is highly

recommended. If water has collected in screen bezel, wipe dry before covering/storing. NOTE: DO NOT

ALLOW SALT WATER DEPOSITS TO REMAIN ON GLASS SURFACE FOR EXTENDED

PERIODS (REMOVE SALT DEPOSITS WITH FRESH WATER).

LONG TERM SALT

DEPOSITS MAY CAUSE PERMANENT DAMAGE TO THE SCREEN SURFACE. Additional

Precautions: Do not operate in temperature extremes (below 32°F (0° C) or above 104 °F (40° C)). Do

not put pressure or contact directly on screen surface. Do not connect directly to power source

without using the regulator supplied. Do not reverse power wires. Do not expose to submersion or

high pressure water. Do not pull or strain cabling as this can break the cable clamp seal.